Saniflo Saniplus toilets

What Houzzers are commenting on:

mike101 added this to mike101's Ideas
May 1, 2013
Capturing shower water
HomeEco added this to Base IDEAS
March 8, 2013
Reciclar el uso del H2O
nanbrooks added this to nanbrooks's ideas
January 29, 2013
Like the profile of the vanity. We have a narrow bathroom so find the narrower vanity is good
mrscarolo01 added this to mrscarolo01's ideas
January 20, 2013
Saniflo Saniplus System
juliogll added this to juliogll's Ideas
September 16, 2012
Good solution
haleymiller added this to haleymiller's Ideas
September 3, 2012
Ejector pump alternative?
Janna Waldinger added this to janna_waldinger's ideas
August 3, 2012
the sink

Saniflo Saniplus

Install a Toilet Anywhere You Want. High Level Of Styling.

Installing a bathroom where you want is often difficult and sometimes even impossible. The main drainpipe is either too far away, or the new bathroom or sink will be lower than the drainpipe, making conventional installation unworkable.

The Saniplus is a system used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. It can handle the effluent from a toilet, sink, bathtub and shower.

The Saniplus is simplicity itself to install; there are just four connections.

The macerator/pump is connected to the spigot of a horizontal rear discharge toilet
The toilet tank is connected to the water supply
The macerator/pump is connected to the small diameter discharge pipe work
The macerator/pump is connected to the electrical supply

The inside of the Saniplus is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and the pump.

When the flush is activated, the water flowing into the Saniplus activates a micro switch in the pressure chamber, which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM. The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor.

The unit pumps the effluent upward to 15 feet and/or 150 feet horizontally (with gravity fall). Once the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again. A normal operating cycle for Saniplus takes about 7-9 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.

In addition to the toilet waste, the Saniplus will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a bathtub, a shower and a urinal. When adding a bathtub or shower, a base will have to be constructed. This base should be made out of a 2" x 6" (minimum) or 2” x 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4”per foot gravity flow towards the pump unit.

The wastewater from other sanitary fixtures is discharged into the Saniplus via two 2-inch inlets on either side of the housing. Either one or both inlets can be used as required. The discharge elbow on top of the Saniplus can be turned either to the left, to the right, or towards the back, depending on the discharge installation. A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit.

This unit has been designed with a vent connection on the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent. The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems. It is also highly recommended for the macerator/pump to be connected to a Ground Fault Interrupter (GFI) circuit.

The design of this model consists of vibration absorbers which enable the reduction of operating sound by reducing the transmitted sounds from any location where such resonance transmission could occur. This new design reduces the operating sound of this pump by 10dB.

Product Specifications

Sold By
Quality Bath  
© 2014 Houzz Inc.
Houzz® The new way to design your home™