It was a local fabricator here in Austin. I cannot remember off hand, but can check if you need it. It is not a tough fabrication...so you may be able to find someone closer to you. It is a trough sink with 2 faucets and drains to the center. The trick was getting the slope to drain correct. This one was a little shallow. Would have been better to make it a bit more sloped.
Dig the rusted sink. Not sure where this goes. Not the basement bath, because we're recycling the vanity from existing upstairs bath. Not the guest bath, because we're probably doing a white job like the previous photo in this idea book. Not the master bath, because we're doing a white rectangular job. Maybe guest bath after all. Let's talk.
It was a local fabricator here in Austin. I cannot remember off hand, but can check if you need it. It is not a tough fabrication...so you may be able to find someone closer to you. It is a trough sink with 2 faucets and drains to the center. The trick was getting the slope to drain correct. This one was a little shallow. Would have been better to make it a bit more sloped.