9,765 plywood ceiling Exterior Design Photos

Timothy F. White
3 Reviews
Morris
Ideabooks3,934
Questions4
a tight fit and therefore applied the wood directly to the vapor barrier and sheathing so there is no rain screen in this case. we had continuous plywood sheathing in addition to the gyp. board so hitting studs was not an issue.
a tight fit and therefore applied the wood directly to the vapor barrier and sheathing so there is no rain screen in this case. we had continuous plywood sheathing in addition to the gyp. board so hitting studs was not an issue. ALSO faux stain my house like this?...
“roof design” — Manson Leyira
Christopher Kellie Design Inc.
1 Review
Pasture Lane - The Farm at Banner Elk
Ideabooks4,539
Questions9
batten on the top? Individual boards, or battens on panels? What is the spacing and sizes of the board and batten? Also, it appears that some sort of plywood was used on the lower portion. Please explain more if you can. This looks like a great way to hold the costs down on that lower section versus the
“Style, colors” — merrywoods
DeForest Architects
7 Reviews
zipper house
Ideabooks19,701
Questions12
siding. Cost is an issue. One builder recommended board and batten with primed plywood and cedar batten. Are you able to place the hardie panel directly on stud (with only tyvek between the surfaces?)or do spacers+plywood have to be set off the stud/tyvek. We are looking for the magic bellet of low
“Paint color” — lockwood799
CITYDESKSTUDIO, Inc.
4 Reviews
Lake side cantilever
Ideabooks2,928
Questions5
The flat roof deck is made up of truss joist wood 'i' joists (TJI) and plywood decking. It has a rubber membrane roof with tapered insulation to create positive drainage toward water drainage locations. The roof was engineered to account for snow loads. The upper level of the house and all interior
a flat roof. It is not possible to determine the deck type based on this photo. There are several possible options for a deck including a regular plywood, steel and concrete to name a few. I would assume it would be steel or concrete due to where the home is located. Snow is always a huge factor and
“Itz gud” — Uyen Campbell
Stonewood, LLC
19 Reviews
Exterior
Ideabooks36,144
Questions26
Typically the batts are at 16" on center. That way the cover the verticle joints between the plywood sheets and can also be nailed to the studs behind the plywood. Assuming that they match a pleasant layout. But, typically, they are 16" on center.
“Colonnes” — jodan01
Coates Design Architects Seattle
23 Reviews
Knowles Residence - Exterior
Ideabooks2,483
Questions4
the soffit material indoors and out is a prefinished birch plywood
Line underneath of alfresco ceiling with timber-look board
House plans without cathedral ceiling
“Bamboo in pots at entry” — gakira1
Court Atkins Architects
5 Reviews
Palmetto Bluff - Jackfield
Ideabooks272
Questions1
help with what are the options for porch flooring? We have exposed upper decking and covered lower decking. The construction is a membrane over plywood decking supported by 2x10. We currently have a thin spray concrete which is stained. Nice but we want it more attractive. Court Atkins did our home
“fence and fire pit” — Amy Renshaw
FINNE Architects
23 Reviews
Port Ludlow House
Ideabooks3,378
Questions3
6. clerestory windows along roofline increase visual height. Wood ceiling is nice but not in our budget.
Plywood against dark roof again.
Ceiling overhangs in wood
“This whole concept fits my dream; including the location!” — Bob Underwood
© 2014 Houzz Inc.
Houzz® The new way to design your home™