Houzz is the new way to design your home.
1,732 4x4 Home Office Design Photos
Forest House in Spring
spaced 4" apart...maybe they are 3/4" x 3/4" sq...but become thinner 3/8" x 3/8" around corner...as a transition...? hope that helps...but not knowing the codes or requirments hard to "cold design" ....cheers- rich
about 4"..( leaving about 3" interior) ... so the total thickness from front view is no more than 6"... leaving enough leg room....
Foley Fiore Architecture
Cutchogue Waterfront Residence
like the 1x4 and the 1x2 and are those boards flush or does the 1x2 set back from the 1x4. Love the look and trying to build same looking bookshelves.
is 9' x 12'. The bookshelves on each side of the room are 14" deep.
9'-0" x 12'-0".
about 10x 10, not including the other part of the room.
It is about 7 x 20 inches on the back end and the arm that is supported by the beam is about 3 x3 '/ the cabinets above the 'arm" house
but need 4 or 6 only ...
idea for 4-drawer file cabinets
office idea 4
Domiteaux + Baggett Architects, PLLC
ceiling is 4x8 sheets of birch veneer plywood with a clear sealer applied.
4x8 sheets of birch veneer plywood with stain on ceiling
MusaDesign Interior Design
Millennium Tower Loft-Home Office
grains of 4x4s. What is this Flooring?
4th floor media/office
Case Study 75 x 26(hi) x 33 http://modernica.net/case-study-bentwood-daybeds.html
white 4 arm jielde lamp
3/4 wall...the 3/4 wall
Laura Manning Bendik
Della Brook Model Home
4x4x4 blocks to showcase antique cameras
David Neiman Architects
Crown Hill Remodel
of a 1x2. The 2x2 enables you to screw vertically through the bottom of it into the bottom of the desk. (make sure your screw length won't protrude through the top of course :) When the 2x nears the front edge of the counter, angle it back at a 45*. You would still screw horizontally through the 2x2
side are 4'-6" wide. The tabletop is 30" deep and the base cabinet is only 24" deep, which leaves some room behind the cabinet for chasing cords & cables back & forth
Hi Handee9 - you may want to try a 2x2 painted cleat on the
2x2 into the wall studs as Da Vinci suggested. As for the best way to attach the cabinetry to the counter, that is done in a similar way, you screw vertically through the top of the cabinet into the substrate of the counter, again with the correct length screw. With all of the screws you install