room with under counter washer/dryer.
Photography - Amy Williams
Are the base cabs raised higher than 36" How much is the gap between tops of W/D and the counter?
Hi. The counter is approx 40" high. The washer and dryer come with specification sheets which indicate minimum clearance for washer and dryer. You would want to check depending on which model and brand you purchase.
are the washer and dryer serviced? Is the toekick moulding easily removed?
I'd like to do a cabinet similar to this; is the washer/dryer cabinet vented in anyway? I was looking at the spec requirements and they indicate venting is required e.g. a mesh or slats about
Hide the washer and dryer behind doors.
Hidden washer dryer, one side could be utility sink and/or laundry storage
We have a small house and the laundry needs to be in the kitchen. We don't want to see the laundry appliances and are wondering if there are any cabinet manufacturers that sell cabinets for washers and dryers.
I'd like to do a cabinet similar to this; is the washer/dryer cabinet vented in anyway? I was looking at the spec requirements and they indicate venting is required e.g. a mesh or slats about the size of a air/heat register.
y for washer and dryers. These pocket doors were designed by me and ordered through my cabinet company. You should go to a kitchen designer to make sure the design works with the specs of your washer and dryer. You need to be aware of width, height and depth when designing. A good kitchen designer will
then washer and dryer at 27" each, and 2" left in total to spare. I need to put a counter overtop of the washer and dryer, and am wondering how is the best way to do that while using the least amount of space. And should I have the washer and dryer 1" apart? If so that means I only have 1" of space
got the washer and dryer so close to the wall with all the water supply and dryer hoses to accommodate?
Did they make the countertop deeper? Maybe higher too?
Thank you so much
Do you know what size and brand of washer and dryer are used in this photo
running the counter over. Only problem is now, the code for my plumber has the water connection box over the counter height. I was going to put the bottom of the counter at 38 to give a little room between top of appliances and the counter. Any suggestions or solutions for this situation?