Workshop M Architecture
Museum District House
good to know, we usually specify 1 -1/2 overhang with 2 1/2 thick coping - very traditional look! Also the overhang creates a shadow line to obscure the
1/2" max. Any more and you risk injury with people coming up out of the water
Michael Fullen Design Group
Like 1 PRO Siris/Coombs Architects what is the fuel source of this fireplace and who makes it August 7, 2013 at 10:12am Like 1
office to check availability and order. September 3, 2012 at 7:29pm Like 1 Write a comment maryckelly wrote: What kind of wall
wall panels are these and where can I find them? Like Comment April 1, 2012 PRO Michael Fullen Design Group The wall is a custom design
casing to the ceiling. Tradition draperies are too short according to the 1/4" break rule, but going all the way to the floor seems like a lot of drapery
I looked in 1 st Dibs but didn't find anything like them. Any other suggestions where I
The end tables were found on 1st Dibs and they're antique rosewood from the 40's
These end tables are original antique side tables from the 1940's found on 1st Dibs
Michael Tauber Architecture
modern cabinetry in tight bathroom
TALL toliet in the pic above this 1, had a flush mech on top dead center, Would you know the make and model of that 1 ? grateful for your reply-husband
Jand5 It is a toto toilet, eco ultra max one piece. model number, 1.28 GPF , #MS854114EG Don't know where you can get it where you are but most
hdsoftail, This room was 5'-6" wide by 8'-7-1/2'. With the 5'-6" being the length of the cabinet in the picture. The room
wall to cabinet at the toilet and the overall width from wall to wall is 5'-6 1/2". The counter at the sink is a hair over 3' wide. Thank you for the question
How many seams behind the sink please? 1 or 2?
I don't have the exact dimensions but I would estimate about 1 1/2"-2".
Rohl 30 inch sink 30x18 8 1/2 deep
1.7M at the deep end, 1.1 at the shallow end.
Do any councils have rules about building structures less than 1 metre from the fence? Would an above ground pool like this be an exception
can work with? Would it still work if you reduced the width of the pool to 1.5 meters? If 10m is the minimum length, what is the minimum width? Wondering
We used 1x8 boards spaced 1/2" apart.
WINDOW/OPENING TRIM: sim to here, with proud jambs in natural 1x wood but protruding farther (cedar? mahogany? ipe?). Barn will be dark-painted
Veranda Fine Homes
The stucco on this home overhangs the slab by about 1 1/2". We use a true masonry stucco with a 3 coat application - Scratch coat
technique is best. However, it seems to come down to three basic approaches 1) Slot cuts 2) Dowel Pins or Screws or 3) In Beds or Threaded Inserts. I did
Front Door - (2) 3090 1/2 round iron w/ full light Bedroom on right - bottom L to R 2060, 3060, 2060