SHOP BY DEPARTMENT
robbiemac_gw

Elongated holes in Mackissic 12PT

robbiemac
2 months ago

I have a Mackissic 12PT Shredder-Chipper that I purchased new in 2013. In the years since then, the holes in the sheet metal sides where the rods go through that hold the screen in place have become elongated. Does anybody know of a good fix for this issue? I was considering bolting on a small (4" x 4") piece of flat stock (1/8"?) with the proper sized hole drilled in it to reinforce the original hole and return it to its proper size. Would this work well, or does anybody have a better solution? Thanks for any help you can give.

Comment