Software
Houzz Logo Print
zumtobel

Maytag A606 halts at damp dry

5 days ago

The washer functions normally until it reaches damp dry. Once there, it runs for a minute, then clicks 2 or 3 times before shutting down. What could be the reason why this is happening? Not because of an unbalanced load, tested it with towel.

Comments (4)

  • 5 days ago
    last modified: 5 days ago

    Putting this into chatgpt came up with this...

    My leading suspects would be the timer contacts or the motor's overload protection. A motor overload protector can click as it interrupts power when the motor overheats or draws excessive current.

    One test that will tell us a lot

    When it shuts down, leave the machine alone for about 20–30 minutes, then try it again.

    • If it works again after cooling down: Suspect the motor overload protector, motor, or a binding mechanical component.
    • If it remains dead until you manually move the timer: Suspect the timer or its contacts.
    • If it stops but the timer and other functions still have power: Investigate the lid switch and motor circuit.


    Other things to consider are...

    • Timer and timer motor
    • Lid switch
    • Motor switches and motor assembly
    • Drain pump
    • Unbalance trigger switch
  • 5 days ago

    Awesome! Thank you so much! Will try and let you know the result.

  • 3 days ago

    Wouldn't you know it! I have run the washer twice now and the problem isn't again happening. The house where it is located is my summer house so the washer is not used often. That, together with its 50 plus year age could somewhat explain. Still, it is highly likely the problem will again happen. So we'll have to wait until then to diagnose as per your excellent reply!

  • 23 hours ago

    The lid switch on this Maytag design affects all functions of the machine so is unlikely to cause a problem with only the final spin operation.

    The off-balance spin "switch" is a bump/latch mechanism that makes the lid switch trigger as if the lid is open. The latch releases/resets when the lid is opened (for the user to rearrange the off-balance load) and closed (to resume the spin).

    The pump is belt-driven by a second belt (not by the transmission belt) and runs at all times that the motor runs. It turns in reverse during agitation so water is forced back up the tub outlet port instead of out the drain hose. A pump binding from bad bearings or jammed with a foreign object would likely cause problems at all times, not just during the final spin.