I have a two year old elm (Ulmus glabra?) seedling in a small pot on my balcony. First summer it grow freely in its pot. During the first winter the trunk got bent over so in the late winter I wired it strait using coppar wire and pinched its top. It was then about 25 cm high.
Next summer the tree grow 10 branches evenly distributed on the trunk and a new top. I pinched those so that the top ones got shorter then the base one to increase the taper. In mid summer I had to remove the wire since it began to cut into the tree. The tree was still bent but not nearly as much as before. It was still about 25 cm high, a thin trunk (1/5 inch) but a good taper.
During this winter only the top has bent. It has started growing now slowly so it is still alive at least and it look healthy to me.
Will it survive a repotting and when should it be done. It has been about 20 degrees Celsius at most this spring, but there is still times with nightly temperatures below 0 C. I will put it in a large pot.
Will it survive another wire this summer? How hard stress is it for a tree to be wired? It doesn't look to hard to me since I don't need to bend it much. (A few cm totally on the upper half of the trunk.)
Will it survive if I continue pinching like I did the second summer (if repotted and wired)?
David.
weissenheimer
nixtrix
Related Professionals
Aberdeen Landscape Architects & Landscape Designers · Longview Landscape Architects & Landscape Designers · Aurora Landscape Architects & Landscape Designers · Chicago Landscape Architects & Landscape Designers · Las Vegas Landscape Architects & Landscape Designers · Elkton Landscape Contractors · College Station Landscape Contractors · Plainfield Landscape Contractors · Omaha Landscape Contractors · Santa Barbara Landscape Contractors · Indianapolis Custom Closet Designers · Poplar Bluff Custom Closet Designers · Manchester Custom Closet Designers · Youngstown Custom Closet Designers · Phoenix Custom Closet DesignersDavid_POriginal Author
AndrewSun
David_POriginal Author