Software
Houzz Logo Print
trace00969

Does anyone 'rig' their own hanging baskets??

19 years ago

Hi everyone......I am just wondering if anyone makes their own hanging baskets.....I ask because I have a really hard time finding anything less than an 8 inch hanging basket, and I need to go to about 4....so does anyone have any ideas as to how I can accomplish this......I use alot of chain, so maybe there is a way there??

Thanks everyone

Tracy

Comments (6)

  • 19 years ago

    I have, but the results were not the most beautiful thing I've ever seen. ;) Still, it sufficed until the plants were big enough to put in a more decorative type of hanger.

    Take a 2"/4"/6" plastic pot and drill a few holes in the *sides* near the very bottom (this will allow water to drain out). Glue the drip tray to the bottom of the pot---the glue seals off the factory made drain holes on the bottom of the pot, but the newly made drain holes on the sides will funnel water into the drip tray (saving your carpet). Then drill three or four holes under the lip of the pot, put in "s" hooks, and attach chains. Be careful that the rough chain does not tear your foliage.

  • 19 years ago

    Tracy,
    What about taking a 4" pot and putting in one of those macrame hangers? You can fit just about any size pot in those, and it turns any pot into a hanging plant within seconds. I get mine at my local nursery, but you can also find them at home depot.
    Gabi

  • 19 years ago

    I get cheap ceramic bowls from the dollar store (50 cents). Use a glass bit lubricated with oil to drill 4 holes in it evenly placed around the rim. Loop any cord from suede lacing to macrame cord thru a hole and back down thru the opposing hole leaving the length according to hanging height you need. Same with the remaining 2 holes.

    I also use a metal or wooden ring that a bowl fits well down into. I get them at craft stores. You can get elaborate and wrap the entire ring in your cord or you can just tie the cord at four points and secure with hot glue, then bring the cords up to hang.

    I also use terra cotta orchid pots with the side slits. Down side of this is you have no reservoir to hold excess drainage water unless you have a little saucer inside. If it's okay with you to take the pot down and water over a bucket or sink it works great. Run any lacing cord thru the side slits one side to the other as I said above.

    With any of these you can put a round jump ring at the top to hold the 2 cords together. Also you can vary your hanging lengths, customized to what you need.

    I have a long black pipe that runs the length of a bank of windows and I can hang many plants from it with a combination of these 3 hangers. I hang at varying lengths which extends my space quite a bit. I make long S-hooks from heavy copper wire which allows me to vary the lengths even more. It looks great too. I found similar color bowls so it doesn't look gaudy or detract from the plants themselves. I want the plant to be the main thing I see, not the hanger. But I also want it all to look good.

  • 19 years ago

    If you look around in a place like Lowe's, you can find one of those slotted wooden basket that are used for orchids. I have a potted hoya sitting down in one on a saucer.
    Just loop the wired hook onto the basket (wired hook comes separate) and there you go! This one is eight inches, but I have seen 4"-5" sizes as well.

    {{gwi:93758}}

    Billy Rae

  • 19 years ago

    The "s" hook thing was great I actually rigged a couple today that way since I have chain on hand.....I am totally going to try the other ideas too, I have a couple of those macrame hangers, but some are so gawdy that I am a little picky.

    Thanks for some totaly useful ideas.

    Tracy

  • 19 years ago

    Trace if you email me, I'll point you towards a Hoya vendor who sells 4 inch hanging baskets.

    GH