johniebgood,

Ask the manufacturer on their web site. their good at answering questions specific to their products. Aloha

I would try to reset the controller. This is listed in the manual as to how to do it, you need a tiny point like a pencil eraser end to press down on the little button inside the box, follow the instructions, I also had to simultaneously press a button on the front of the controller to "reset". Mine did reset, my problem was that I only showed two zones on the controller and I had three zones installed. This error occurred after the installer brought a new rain clik and receiver and installed those but did not check to be sure I still had three zones. I got them all back by doing a reset. Good luck.
Debra

I agree on the reset. But, suggest you write down all your program information first.

Posted by steve_l (My Page) on
Thu, Nov 11, 10 at 9:40
I agree on the reset. But, suggest you write down all your program information first.

I wished I had thought of that before I killed the power to the controller. I was on my way to work and didn't think of it.

I'm going to try the reset. And if that doesn't work I'm going to try contacting someone on Hunter's website, as someone suggested. Thanks.