Software
Houzz Logo Print
deercub

Deer GT-235

18 years ago

One for the pros.

I have a 2000 GT-235 I bought used last year and it runs great. When I bought the GT I change the hydro fluid and always keep it between the marks on the tank in back. I also notice before I start its in the middle of the low and full lines but when done its near the top of the cap. I assume this is due to expansion and never paid attention to it. Well today after I cut the lawn then I put down some fertilizer and all went well. When I unhitched the spreader I saw hydro fluid ooooozing out of the cap of the little tank. I know it will go back down but is this something that I should look into or care about?

Pleas give me your thoughts-Rick

Comments (9)

  • 18 years ago

    Maybe the fluid is getting hotter than it should.
    Are the cooling fins/fan etc. clean/intact?

  • 18 years ago

    Yea I check that all the other day when I gave it a once over. I even checked the belts and all is good. Any idea what else could cause that fluid to rise like that. I may just change it out again over the weekend and see what happens.

  • 18 years ago

    Maybe the level marks are for hot fluid, like an auto transmission? Does the owners manual specify fluid temperature when checking the level? Maybe it's just a little over-filled and will find its normal operating level.

  • 18 years ago

    It has a high/low mark so you just stay in the middle like the antifreeze tank on a car. I guess I'm just going to change the fluid and fill it to the low mark. Its only done it this one time so I'll just have to keep an eye on it.

  • 18 years ago

    I have a 1999 GT225 which has the same hydro, and having changed the fluid more times than I care to think about ( But that's another story), I have never had this problem. I ususlly get the fluid as near the full mark as I can and that's where it stays.

    Some of the reasons I can think of that would make the fluid expand are: (1), It has air trapped in the transaxle that is mixing with the fluid, and this could be caused by.. (2). You are using the wrong type fluid. The manual is very explicit in the type fluid you can use. "Low viscosity". (3) You are not filling the hydro using the proper procedure, and there is a proper way.

    Fluid change is recommended every 200 hours BTW

    Do you have the owners manual?

  • 18 years ago

    Yea I do and I did use the right hydro fluid. I going to change it out again before I run it and see what happens.

  • 18 years ago

    I buy the John deere low viscosity hydro fluid, and it comes in gallons and quarts. as I remember it take 5 quarts to fill the hydro, or it's supposed to, but I always had trouble getting the last quart in without over filling.

    Now that I think about it I suppose that one function of the reservoir is to do exactly what you have observed it doing: provide a space for expansion of the hot fluid. It could be that the day you saw the tank bubble over was on a day the transmission got hotter than it usually does. It is also possible that you had overfilled it a bit. Anyway, if you are using the right fluid and you have filled it the proper way, and the tractor is otherwise running fine, I wouldn't worry about it.

  • 18 years ago

    Yea I'm thinking the same thing. Thanks

  • 15 years ago

    What kind of fluid do you use when changing hydro fluid, how much and is there a filter that also needs to be changed.

Sponsored