Software
Houzz Logo Print
pezzuti9

came up with an idea

19 years ago

There may be some of you out there that have already tried this approach. I was just finishing up grafting a few fruit trees when my fig cuttings arrived from Davis. So I finished with the one graft I was doing and started to prepare clear plastic cups to pot up the cuttings that I received. I also placed the larger cups that the cuttings are in with drain holes into smaller cups that have no drain holes. That will allow the water to collect in the smaller bottom cup and when I see itÂs getting almost up to the cutting container IÂll just dump it out and place it back under the larger cup again.

They where a little longer than I thought they would be and I did not want to cut them to shorter lengths. After potting them in large clear plastic cups there was more above ground than I wanted. I donÂt want tot use plastic bags to cover them with because I have them close to the oil burner. In fact they are on top of it in a heavy plastic tray. So what I did was wrap the sections that where above ground with the parafilm tape that I was just using grafting. I did not pull it up too tight and when I got to a bud I just taped around it leaving it exposed. I figure if it works for keeping the graft and scions from drying out then it may work as well to keep the fig cuttings from drying out as well. I did not do all of them just two of each just to see what happens.

Lou NE., PA

Comments (4)

Sponsored