Software
Houzz Logo Print
jvat

Nutrients Clogging Air Stones, oxygenation problems

15 years ago

So a few months into my first NFT system I am coming across problems keeping my oxygenating air stones bubbling freely. I have a 6" stone in the main tank that runs from one of the two independent outputs on my air pump. I have the second output split at a Tee and providing air to two separate 1" cylindrical stones that are placed at the topside of each of the two channels.

My stones keep clogging, Air flow (bubbles) is severely limited after just 24 hours of run time. Currently, I pull the stones out and run them in a bucket with just tap water virtually every evening. The stones seem to clean themselves out and the bubbles increase greatly after just a couple minutes in the tap water rinse, but then the next evening when I get home from work, its the same story, Clogged stones providing very little bubbles / oxygen.

Does anybody have any Ideas? My Nutrient solution is the standard Hydroponic liquid type and I keep it below 1500 PPM. Are there any alternative products? Do I really need the stones or can I just run the tubes straight into the channels and reservoir?

Comments (5)

  • 15 years ago

    It sounds like you don't have enough air running through the stones. They do clog, but you shouldn't have to clean them every night.
    you could run them without a stone. Others on the site have used soaker hose effectively. Another option is to make an air lift to create a waterfall for aeration. basically float an inverted L shape of pvc on a piece of styrofoam. attach the end of the air tube to the bottom of the pvc pipe (It'll be submerged) the bubbles lifting will push water up and it will come out the horizontal piece and fall back into the water. search this forum for both aeration and air lift. you should be able to find pictures on the first page or two.

  • 15 years ago

    Thanks grizzman,

    My Air Pump is a "60 Gallon tank", silent run type. I am running without the stones for now. I dont know if it is "as effective" as using stones but I am seeing very nice root growth for the time being.

  • 15 years ago

    I just noticed you had it split to three seperate stones. that means less air per stone.
    I think the primary way to infuse air into the water isn't the bubble size but the amount of disruption at the surface. That's why waterfalls make such good aerators.

  • 15 years ago

    I agree the air lift design works very well, as well as the disruption on the water surface infuses quite a bit of dissolved oxygen into the water. But the air lift design dosen't work on falling water alone, the water is typically raised by many tiny air bubbles that churn, and mix the air with the water as it rises. So it really combines the best use of air bubbles (churning with a column of water), as well as surface disruption from falling water. Quite efficient.

  • 15 years ago

    Thanks guys. I'll have to do my research on that design. The single 6" stone in the main tank does did not get nearly as clogged up as the two smaller stones I had at the top of the NFT channels. I truly like the idea of bubbling the water as it goes through my system.

    Here is a link that might be useful: The original setup

Sponsored
AIS Renovations
Average rating: 4.5 out of 5 stars15 Reviews
Custom Craftsmanship & Construction Solutions in Franklin County, Ohio