Software
Houzz Logo Print
jamesy50

CRW Cages

16 years ago

I have been given a bunch of CRW for cages. My question is do you remove the bottom horizontal wire so you can push the vertical wires into the ground? How do you secure them from falling in the wind? Thanks, James

Comments (8)

  • 16 years ago

    James,

    That's what my dad always did and he never had to stake, but he was in a very sheltered location where surrounding buildings, trees, etc. gave his garden a lot of wind protection.

    I stake cages with wooden or metal stakes. It is a lot of work, and most the time you don't need the stakes, but when a big thunderstorm hits with high winds, if your cages aren't staked, they can blow over if the wind is pretty high.

    Dawn

  • 16 years ago

    Termites eat my stakes sometimes, so I now cut off the bottom like you mentioned, push them into the ground, and use small metal posts or 5' pieces of rebar to secure them. I don't do them all. Instead, the ones on the east sides of my rows I simply tie to other cages near them with strong stretch tape. My rows run N to S with two rows right next to each other, so I only have to use posts on about 60% to 70% of them.

  • 16 years ago

    I cut the bottoms off of mine and stake every 10 feet or so, then run wire on both sides of the row, tied to the stakes. I've never had any blow over yet with this method. (Watch it happen now that I've said that!)

    Diane

  • 16 years ago

    My dad had always removed the bottom ring and "stepped" them in and that's the way I had always done it until this year. Last year I had a terrible time with the wind and by the end of the season I didn't have but a couple of vines that didn't end up broken because the cage blew over.
    This year I decided better safe than sorry, so I went this week and bought some 1/2" metal conduit and drove a piece on each side of the cage and zipped tied the cage to the conduit. I thought it would be good and sturdy and last a while.

    A dear family friend (and my "extra" grandpa), used a setup similar to Diane's. He put a t-post every so often, maybe 10-15', then he would weave a rope through the top opening of the cages and tie it off to the posts. I initially thought about trying this, but my tomatoes are planted in a couple different locations and they don't always line up like I think they would have to for it to work.

    Michelle

  • 16 years ago

    There is some good stuff in this thread. I need some more supprts to go with the CRW that I will cut up tonight. I wonder what is cheaper and easier in the long run: rebar, t-posts, u-posts, conduit, or something else.

  • 16 years ago

    I use t-posts because they last dang near forever and are sturdy as can be. Rebar is too wobbly for my taste (unless you get the really thick & expensive stuff). Conduit isn't sturdy enough for me. Never heard of U-posts. Will have to go google those.

    Diane

  • 16 years ago

    I'm with Diane here. Six foot T posts are the way to go here in Oklahoma where the wind does, well, what it does here. They last forever in garden use and are well worth the little trouble they take to drive and pull.

  • 16 years ago

    I use T post and then tie 1/2" rebar to them, then sorta use the Florida weave. I also have a 4 or 5 inch pice of 1/2 pipe welded or tied to the top of my T post, about 1/8 lower than the top so the driver wont hit it. I then stand a 2.5 foot piece of 1/2 inch rebar in the short piece of pipe so I can take the trellis height up to near 7'.

    I know this is a lot of money and a lot of work, but I have had this material a long time and expect it will out last me.

    Larry

0