Software
Houzz Logo Print
nellym_gw

Bluestar 30' Range with 30' Hood?

16 years ago

I am considering the Bluestar RNB304BSS range. Specs says 36" hood is required. Problem is, if I get a 36" hood, I will lose all of my upper cabinets. Have any of you put in a 30" hood with the range? and what has your experience been like? Is 600 CFM adequate? or is 1200 CFM better?

Comments (3)

  • 16 years ago

    I have a 30" range,not pro style much less with pro power,with a 30" hood and I have charred my cabinets.

    I use cast iron pans and griddles and enjoy high heat cooking. Therefore I am getting rid of those cabinets regardless when I get my 30" RNB.

    What is adequate depends on how much grease and heat you are willing to tolerate.

    The general consensus is 1 cfm per 10 btu of power. Plus a 1200 cfm blower operating at half capacity is alot less noisy than a 600 cfm blower operating at full capacity.

    Engineers that want maximum heat,grease,and smoke extraction would get a 36" wide and 27" deep range hood with a 1200 cfm blower for a 30" RNB.

    What is "adequate" depends on your standards,expectations, and budget.

  • 16 years ago

    Interesting deeageaux, thanks for your input. I had intended to do wok cooking on the Bluestar - it sounds like the 36" is a must. I have been researching range hoods and max depth appears to be 24" for conventional brands and noise (sones) is a consideration too. Have you been researching hood fans in anticipation of your own RNB?

    You mention that you have charred your cabs. My backsplash is made of glass tiles - would they be damaged from the high heat based on your experience?

  • 16 years ago

    I have been looking at chimney style wall hoods.

    The only hood that I have seen that is 27" depth that is not life styles of the rich&famous expensive but still cost a pretty penny is Modern Aire.

    Glass tiles should be fine.

    I am buying dark brown(rootbeer) glass tiles and dark brown grout for a 10 sq ft area behind my RNB.I also plan to use the 1" island trim.

    I also will be adding a 22k burner on the right rear to replace the 15k burner for a total of three 22k's plus the simmer burner. As a result I will be putting plain cheap tile on the back wall below the counter all the way to the ground. The oven also puts out major heat and this will protect the wall space directly behind the range between the bottom cabinets.