Shower glass panel installation ?

16 years ago

Hi, in final stages of finishing master bath remodel. We are getting shower glass installed next week. It will consist of one fixed panel and a door hinged off a fixed wall. The glass is 3/8", Starfire with showerguard. I have question re the fixed panel glass installation..

2 glass installers recommended using brackets/clamps on the vertical side to secure to the wall and using a U channel on the bottom. The glass will rest on a Silestone top and measures around 42 x 42 inches.

The guy I'm going with suggest just using the clamps on the side and securing the glass straight to the Silestone with silicone.

Does U channel offer any structural advantage, like protecting the glass longterm? Thanks in advance.

Sort by:Oldest

Comments (4)

mike_home
16 years ago
The U channel will hold the glass more securely than the silicone. But it does take away from the look of a frameless shower installation.

How wide is the fixed panel? It is narrow it may be OK. I don't know if I would feel comfortable with just silicone holding it. Why not put on bracket in the corner opposite the wall? This is what the installers did for my shower. The bracket will give extra strength to the silicone. It will also look better than a U channel.
mahnrut T
16 years ago
We have the same set up I think (see my pics in the gallery - small bathroom finished). We have an 18" fixed panel and a door fixed to the other wall. We have clamps on the upright edges of the glass and one clamp on the bottom of the fixed with silicone but no channel. A high end place in the DC area did it and when I said that I did not want a channel there was no discussion of it being a problem.
Related Professionals
Fayetteville Kitchen & Bathroom Designers · Bloomington Kitchen & Bathroom Designers · Hagerstown Kitchen & Bathroom Designers · St. Louis Kitchen & Bathroom Designers · Clarksdale Kitchen & Bathroom Designers · Spring Kitchen & Bathroom Designers · Temecula Kitchen & Bathroom Designers · Fort Collins Kitchen & Bathroom Designers · Fayetteville Bathroom Remodelers · Chico Bathroom Remodelers · Florence Tile and Stone Contractors · Spring Tile and Stone Contractors · Hartford Tile and Stone Contractors · New Haven Tile and Stone Contractors · Spokane Tile and Stone Contractors
marisany
16 years ago
This is timely for me. My frameless shower glass was just installed today. I have two concerns.

First, I'd been told (and the proposal specifies) that there would be u-channels along the bottom of the two fixed panels, and on the vertical part of the "notched" panel that goes around the tub deck. (The shower glass has one 36" wide x 60" high fixed panel along the marble tub deck, and another narrow fixed panel at 90 degrees to it; the narrow one meets the door, which is attached to the opposite wall with clips.) The large panel is held into the wall with two clips. I thought there would be u-channels along the bottom of both fixed panels, but the installer used only silicone. I am worried about safety.

My other concern is that they cut into the marble tub deck! I'd been under the impression that the glass panel would be "notched" to go around the tub deck. I have emails in which this was discussed. The shower guy now says that this would not have been safe, and that cutting into the tub deck is the standard way of doing things.

Any thoughts on this?
cansari
16 years ago
mdsun:

What do you mean by the glass will rest on a silestone top? Do you have any pictures of the finished shower?