Software
Houzz Logo Print
helenore

Basement Stair options - Suggestions?

19 years ago

Like another recent poster, our basement steps were covered in vinyl (some really old stuff) and I'll be sanding to remove all traces of the vinyl adhesive, etc.

Problem: Our house is about 80 yrs. old and the wood is ridged and some of the treads are worn in the centers. It reminds me of the stairs of a charming inn we stayed at. But in some places it goes beyond "charming."

Does it sound likely that just sanding would do it, or would that mean sanding too much off?

Will a regular wood filler work on the steps/landing or should I look for a different product meant for floors?

Comments (4)

  • 19 years ago

    Can you post a picture? How deep is the wear?

    Also - what kind of adhesive was used for the vinyl? You should make sure it doesn't contain asbestos before sanding it; the test is about $10 per sample.

  • 19 years ago

    Thanks for the asbestos tip! I'm happy to chip off the bits of remaining "backing" rather than sand it.

    I went back and looked at it - I can't post a pix - but it isn't rickety, just ugly. Under the vinyl we found that the old paint was worn off in places and the wood has gotten a little dry; some of the grain is separating a bit. Mainly I didn't know if "regular" wood filler will work - if it can stand up to being walked on, over and over and over again.

    Seriously, if an extra coat of paint would hide it enough I could be persuaded to go that route, too.

  • 19 years ago

    How about painting the edges and using heavy duty nonslip rubber stair treads. Ive seen some that come over the edge of the step and are glued down. Or you could just use the flat ones if your steps arent that bad. They look okay and they would make your stairs safer too. Painted steps might be slippery.

    Is this a basement basement or is it finished.

  • 19 years ago

    Thanks for your input :-)

    It's sort of half basement-ee; meaning, there's wainscotting w/ painted drywall walls above, and a drywall ceiling; but rather than lower the ceiling about 6 inches to cover the pipes, we left them exposed. The floor is a sheet of the cheapest vinyl we could find (I'd like to change it to an inexpensive click together "wood" laminate.)

    I saw Martha Stewart do a coat of sand paint on steps - in strips - to prevent slipping; followed by a top coat of plain floor paint.

    We did the entry portion of our porch floor that way and it isn't slippery, even in this dripping boot weather.

    (I wouldn't bother with the strips - I'd just do the whole surface of the tread.)

    I think I will THOROUGHLY clean the steps, use wood filler where REALLY necessary (and hope that it holds up), then prime. Then we can decide if we like how they look enough to go forward.

    We have to finish that back stairway (walls, ceiling and floor!) It is by far the ugliest part of the house - and probably the only place left in the house that I don't want anyone to see. (That 's an exciting thought!)