Software
Houzz Logo Print
tetrazzini

Tentative kitchen lighting plan -- is it too much?

18 years ago

Hi. There's a lot that I don't understand about lighting, but I've got a tentative lighting plan for my kitchen. I could really use some help -- I don't know if it's overkill, or if I've chosen the best kind of lights. My goal is first to have good lighting, then to have them be energy efficient. I'm planning to use recessed lights around the perimeter. I've ruled out CFLs because I broke a bulb the other day and don't want to have to worry about the mercury! Do incandescents make sense anymore? Are halogens more efficient? I'm thinking of using halogens or LEDs. My concerns about low voltage halogens are that the transformers could be problematic, and that the light cast will be spotty rather than broad and overlapping. So I'm thinking maybe I'll use 5" cans and hope that LEDs will be available for them soon. My concern about line voltage halogens is that they'll be "hot", although I don't know HOW hot people mean when they say this. IS there an advantage of halogens over incandescents?

GENERAL INFORMATION: The ceiling is 8'8" high. The cabinets will be off-white, with a white marble counter around the sink, and butcher block on the others. Floor will be off-white tile.

THE DIAGRAM: There will be 3 zones of recessed lights, so they don't all have to be on at once. There are 11 total, 4 over the sink area(east, under windows), 4 along the south wall, and 3 along the north wall. I didn't put a light over the stove because there's a halogen light in the range hood. There will also be 2 pendants over the island. These will light the island, but will they also provide ambient light to the rest of the room? I have 2 different fixtures in mind. One uses 100 watt bulbs, the other 60 watts. Which do you think would be better?

Do you think 4 lights over the sink area is too much? What about the 4 lights on the south side: too much, too little? Do you think bulbs should be 65 watt or 75 watt? Are there any other things I should take into account that I haven't mentioned?

Thank you so much!

If anyone would like to answer a few technical questions about light, I have a few of those too. I know there's a way to calculate the lumens needed for an area, and the amount of light that actually reaches a given surface. It has to do with the angle of the cone and the wattage, I think. That helps you figure out the overlap so you know where to place the cans, correct? If I knew how to do this, I wouldn't have to ask any of the other questions! Can anyone explain how to do this? I'm having a hard time understanding the sources I've seen so far. Thank you again!

From House

Comments (2)