Software
Houzz Logo Print
marcia_m

how to prevent wavy borders?

17 years ago

As someone fairly new to quilting (I've made a few quilt tops), I've had trouble with wavy borders. What is the cause? And how can I prevent them?

Thanks for sharing your know-how!

Marcia

Comments (7)

  • 17 years ago

    Wavy borders are caused by lots of different things. Non-square tops, bias edges stretched out, and uneven sides, to name a few.

    After you complete your top, take the largest square ruler you have and cut your four corners square.

    Then measure each side in three places: along each end and once in the middle. You'll usually get three answers...average these together. That is the length you need your border to be. If the border piece is shorter or longer than one of those measurements you ease your top to fit.

    After I add all my borders, I re-square up my corners before added binding.

    Here is a link to another explanation. She swears not to take 3 measurements and average. She says to take on the center measurement. Either way, it's a good explanation...with problems/solutions.

    Hope that helps

    Here is a link that might be useful: Adding borders

  • 17 years ago

    Mine usually wave because the top isn't square. I have become very careful about squaring the top before measuring for the border.

    beverly

  • 17 years ago

    From your suggestions, it is clear I need to square up the corners before adding the border. I don't think I've seen that suggestion in anything I've read. I have squared up my tops after quilting and before adding the binding.

    Thanks for the help.
    Marcia

  • 17 years ago

    When measuring borders be sure and measure width across the middle of the top from side to side rather than measuring at the ends.

    Do the same for the length.

    Cut borders to width and length measured. Pin to fit the top. Start pinning at the ends and middle, then halfway between the middle and end. Continue pinning this way until border is pinned on. Any extra fullness will be evenly worked in as you go.

    This method usually prevents wavy borders.

    Krissie

  • 17 years ago

    Oh, a hint. If there is fullness after pinning your top & border, sew with the fullness down. Your feeddogs will help to ease that in without puckers.

  • 17 years ago

    I have sometimes had this problem - thank you all for the advice!!

    goldie

  • 17 years ago

    Thank you for the help. Luckily, my problems aren't as bad as the quilt on the linked page!
    Marcia

Sponsored
Industry Leading General Contractors in Franklin County, Ohio