Software
Houzz Logo Print
bindersbee

Peeling Paint- How do I fix this?

16 years ago

We are finishing our basement on a budget. I have a lot of experience painting walls but apparently not quite enough. My neighbors next door just finished their basement and know nothing about painting thus they had someone spray the paint on in their basement. They were kind enough to offer up their leftover primer (Glidden brand) and, trying to stretch my budget, I accepted.

BIG mistake. I have used their primer in 2 places over the bare, clean drywall. In one area, I have painted 2 coats of SW Duration paint over the top. I went to remove the 'sensitive area' painter's tape and it peeled up whole pieces of my paint! It was like there was no primer under it at all!

I will have to re-paint this wall but I'm not sure how. I've never had this happen before. I am thinking of sanding the wall with 150 grit sandpaper to smooth it out and get up any other loose paint. I will then clean and re-prime with the same Zinsser 123 that I've used in the basement bathroom then paint again. Will that work? Other suggestions? I am at a loss here.

Luckily, this happened RIGHT before I was going to paint the other area that had been 'primed' with this stuff. Oh- and as I was finishing applying that primer yesterday the neighbor's kid tells me that they had spilled some mineral spirits into that particular bucket of primer. They never mentioned that when they gave it to me. I'm guessing that is part of the reason for the problems. I will re-prime that bedroom before painting today.

I am trying not to be annoyed as I know they had good intentions and simply didn't know any better but I AM annoyed as it is a setback for me. I thought I knew better! Gah!

Lesson re-learned: NEVER apply $45 gallon paint over cheap primer!

Comments (6)

  • 16 years ago

    It's not necessarily the primer itself. Not sure if the mineral spirits would change things, very well could have, but in my opinion the cause of your mishap is that the tape should have been removed immediately after you painted before the paint was dry. If you have tape anywhere else you've not yet removed, score a line along the edge of the paint before attempting to remove the tape.

  • 16 years ago

    I've used Zinsser "Guardz" primer with much success, it's claim to fame is sealing damaged drywall--FWIW I've used it over messed up wallpaper removal where it's impossible to get all the glue off. Check it out. Whatever you do I'd advise a small test patch before proceeding.

  • 16 years ago

    Basements are damp, and your paint simply isn't drying. You would most likely have had this problem even with the best brand of paints. Removing the tape immediately and slowly is your best defense, but in these situations if you can paint the room without it, that's the way to go. If you must use tape, try the green one instead of blue.
    If the primer is water-based, not sure what the negative effects of having mineral spirits mixed in it. I would think you would have had difficulty in the application process, but that's never happened to me, so don't know.
    To repair those areas that peeled, I would use wallboard compound, sand and prime. Bullseye 123 is fine. If it's new, unfinished drywall, I would use a PVA primer.

  • 16 years ago

    I found that I have to remove the painters tape before the wall begins to dry. Now, I just don't use the painters tape. For me, it's just easier to not tape and spend extra time doing it without it.

  • 16 years ago

    I don't usually use painter's tape but that certainly COULD be the problem. I used it this time because I was painting an accent wall a darker color than the adjacent walls and the lines needed to be perfect or it would be glaring. I may paint the closet in my son's room and see if I have any issues.

    While I know MOST basements are damp, I live in ultra-dry Utah where we have single digit humidity year round (if any). The paint is dry in this case though I know that can be a problem.

    Is my method of fixing my mistake okay? Should I re-prime the unpainted room or not?

  • 16 years ago

    I'm trying to remember what I did when this happened to me when our daughter and I were painting our new home seven years ago we made the mistake of leaving paint on in one room and this happened to us. I think what I did was carefully remove the loose paint, sand the edges lightly in hopes of removing any signs of the mishap the repaint.
    I've been in lots of pain this past week which causes memory lapses so I can't guarantee I'm remembering this correctly. It should work though, especially if you prime after sanding. Good luck!