Software
Houzz Logo Print
sydmad2010

OTR microwave install

16 years ago

Has anyone installed a new OTR microwave themselves - is it easy? did you have to drill through a backsplash - we will have to drill through our new glass tile backsplash and it makes me nervous!!

Comments (6)

  • 16 years ago

    Can you take the backsplash off in that section?

  • 16 years ago

    I am just about to do this myself.. tomorrow.

    I would remove th backsplash tile as suggested. OTR microwaves have very tight tolerences and a 1/4" of
    tile on the wall is going to make it stick out
    a 1/4" from the cabinets making it look funny.

    If you leave the tile.. dont worry about messing it
    up. You wont see it behind the microwave.

    DIY_Mike

  • 16 years ago

    the old backsplash is still there, new is yet to be installed, but you can see the last row of tiles underneath the microwave, so that row at least needs to be replaced w/ new tile. tile guy told me the wall needs tile all the way up so it is a level surface to install micro on....

  • 16 years ago

    It's not that hard to install and usually there is a template, but you do need two people to lift and hold it.

    We installed the microwave first and then tiled up to the underside just like under cabinets.

    It's not a good idea to keep some of the old tile behind the microwave and new tile under. If you have existing tile, then you would remove all the tile first and install new tile board then install the microwave on the new wall which is now level. Then you tile the wall under it with new tile.

  • 16 years ago

    steff 1 - thanks so much - that makes sense now! don't know why i couldn't figure that out :)

  • 16 years ago

    DH I and I have put in a few - most recent in 2006.

    Were is the plate that attaches to the wall. You also drill holes in the upper cabinet and put in screws to help hold it - but the main weight is carried by the wall plate.

    Here is the unit installed.

    In 2009 we took out the MW and took out the wall - this shows the supports we had added to the wall to attach the back plate to.

    Learn from our fail - we had trouble taking the unit down and had unhooked the latch. It would not give (vent was holding it up) and we both took our hands off the unit. DI moved the vent just a bit and WAM! the MW flipped down, bashed into the wall (with my hand in between). The unit stayed on the flange of the wall plate, but the door tweeked enough that it would no longer shut properly.

    The dent in the wall about the level of the outlets is where my hand was as I tried to "catch" the unit.

    We had planned on giving it to a friend, but it ended up in the dump instead.

    BTW - this is what it looks like right now - yea, four years later and STILL not done LOL!

    Cathy