Software
Houzz Logo Print
towsonite

Newby, Propagating Boxwoods

11 years ago

Hi, I purchased a boxwood to propagate, a tray and dome, made sure it wasn't patented to keep the feds away, and have my rooting hormone, perlite and peat ready. So, from what I've read I should be taking 4 to 5" cuttings, removing all but top inch or so of leaves and need to stick it into the pot. I'm planning to use a 50-50 perlite/peat mix, though I've seen others saying sand is better. And, that's about the extent of my knowledge.

(I'll add numbers for clarity) 1) I was planning to use 4" or so square pots. Is that a good size or would you just start them out in a tray, not pots, and transplant later? This is a smaller variety of boxwood, so I don't expect them to get much bigger in a year. Once planted, 2) how often am I supposed to be watering them? I'm assuming moist, not damp and never dry. 3) The dome has vents on the top and side that can be adjusted. Should they be closed, open, or somewhere in between? 4) Should I keep them out of direct sun, is filtered sunlight best? I have a maple tree that I can use to provide any variety of sunlight or complete shade. 5) When trimming and removing leaves, I'm assuming I should use scissors to get a nice, clean cut, but should I try to get down to wear it starts turning woody (brown specks) or would the first 4 or 5" even if green still be okay?

Sorry for the number of questions. I tend to over-think things, in case you can't tell.

Thanks for your help!


Comments (2)

Sponsored
More Discussions