Software
Houzz Logo Print
massimiliano_allegri

how to shade Skylands

I put a container-grown 4-foot Skylands in the ground this Spring. It gets near full sun, I am in Philadelphia. I am starting to see some brown needles. I have read about the need to shade these until they establish. Can anyone show examples of how to do this?

Comments (12)

  • 11 years ago

    hopefully dave will post his pix ...


    but let me tell you ... until this plant gets fully ESTABLISHED ... meaning its roots settle down .. and the plant starts growing to specs ...


    most likely.. you will get heat of the summer browning ...


    AND THAT IS NO BIG DEAL... presuming watering is all done properly ...


    i have had pines .. dragon eye.. with half white needles... that dropped every needle.. after every winter.. for two or three years ... and that is where i figured out the ESTABLISHMENT idea ...


    the damage is already done on yours... those needles arent going to heal.. and look better ...


    but it probably wont hurt to rig something up ... BTW.. what zone is Phili??? ...; is this plant favorable to that climate????


    good luck


    ken



  • 11 years ago

    Here's a photo of my new four footer in 2012 with my rig shading it from afternoon sun. I used two 8 ft conduit pipes, smashed the ends with a large hammer into flat points so that they would pierce the ground better, and hammered them into the ground from atop a ladder. I then drapped shade cloth over the poles and a attached it with zip ties.

    I don't have a photo of it but I ended up needing to make a canopy overhead as well due to the sun peaking over my shade cloth and burning the top of the tree. Burnt leaders aren't fun.

    After two full growing seasons with the shade cloth protection it acquired enough root mass to supply sufficient water to the needles and I removed the shade cloth. it's been a happy camper.

    2012


    2015


  • 11 years ago

    thanks guys, very helpful information. My tree looks exactly like your 2012 picture, plus some brown needles on the upward surface of the branches. What is the cloth you used?

    Philly is zone 7.


  • 11 years ago

    It's shade cloth that my mother in law gave me. Not sure what kind it was. You can get shade cloth from your local hardware store or simply Google shade cloth and you'll have a hundred options for sale.

  • 11 years ago
    last modified: 11 years ago

    I did a story in the Conifer Quarterly a year or two ago. Here are two photos I found in my old Photobucket album.

    Only shade the south/southwest side. Easily removable if you use 3/4 EMT conduit driven in the ground. Use 1/2 EMT for fabric support. The 1/2 will slide into the 3/4 EMT driven into the ground to support it. Only shade in summer. Remove in October and began again in May. Minimum of two years. Some areas longer. Depends upon your micro-climate.

  • 11 years ago

    thanks very much Dave, I will try to come up with something like that.

    Garen I like how there's kind of a gap in the middle of your Skylands, great looking tree.

  • 11 years ago

    Ken, actually Sara Malone wrote the story for CQ. All I did was provide the know how.

  • 11 years ago

    i meant here ... now.. and back in the day ...


    props to sara also.. for recognizing brilliance.. and adding her own ...


    ken

  • 11 years ago

    This could come in handy for some rhododendrons. Thanks for the suggestions.

  • 11 years ago
    last modified: 11 years ago

    I live in zone 5 and planted a 5 ft Picea orientalis 'Skylands' in full sun in 2010. I used a sun shade made of burlap stapled to several 1/2 x 1. Over winter I continued that shade all around to give winter protection. I did that for 2 years. I never saw any damage due to sun or cold on that tree. It is now 10 ft tall, and is beautiful.