Software
Houzz Logo Print
mtvhike

Pocket Door installation problems

10 years ago
last modified: 10 years ago

When I commented on Jellytoast's thread, I said that I didn't see any problems, but that was before I started. I am having difficulty with the terminology, and comparing the written instructions with the installation video. I have a Johnson 2710 series prefabricated pocket door frame, and the video is for the 1500 series kit. The prefabricated frame comes in two pieces, the frame itself, and the top piece, which I guess they call the header. Johnson says "Nail header into box frame, square with jamb". Later they say "Apply wall material BEFORE REMOVING POCKET SPACER BRACKET". Well, there is a pocket spacer bracket at the top of the frame which prevents nailing the header. I can slide (barely) the header into the frame below the bracket, but the bracket prevents the top of the header being flush with the top of the frame. If I had to "wing it", I would remove the top bracket.

The diagram for this installation also refers to a "split header, not furnished". What is that? Is it simply trim? I attach their instructions.

Comments (6)