Software
Houzz Logo Print
joe22305

Radiator connection

10 years ago

Hello!

In order to install new flooring under a basement radiator, I recently drained my system, disconnected the radiator and replaced the pipe fittings (the radiators valve and union joint, and a drain valve below it). These parts were all original and had been leaking.

After reconnecting and filling the whole system with water again, there didn't appear to be any leaks in my new work. but when I went to check it out this morning there was a quarter sized puddle of water under the valves. I think this leak is coming from the short nipple going into the radiator valve.

My question: Do I need to drain the whole system to attempt to tighten the pipework? Is there a product I can apply to the joint that would stop this minor leak?

Thanks for your insight.

JB