Software
Houzz Logo Print
toolbelt68

A simple watering system without drip units

9 years ago

The diagram shows how to water 8 plants with equal water going to each plant. To accommodate more plants just install more posts around the garden and run 1/4” hoses to them. To keep the water equal install Tees in the Feed hose or another tap in the 1/2 inch poly hose.

The timer is optional but will allow you to do something else while the plants are being watered.
To determine how long to leave the water on just put a container at the end of a 1/4” hose and time how long it takes to fill the container.

What you will need:

  1. A Pressure treated 4x4 post 2 1/2 feet long.
  2. Timer

    3) Back flow preventer (See note on diagram)
  3. Connector to attach 12 inches or so of 1/2 inch poly hose to the Back Flow preventer
  4. 12 inches or so of 1/2 inch poly hose
  5. A unit to close off the end of the poly hose. One such unit looks like a figure 8. You slip it onto the hose, bend the hose back onto itself inserting the end into the open hole of the 8.
  6. A 1/4 inch connecter that you insert into the 1/2” hose (they sell a punch for making the hole in the 1/2” tube.)
  7. 1/4 inch Tees
  8. 1/4 inch hose (sold in 100 and 250 foot rolls)
  9. Staples to hold the Tees onto the post
  10. Tie Wraps or a small board to hold the hoses in place.
  11. Small nails for holding the small board in place
  12. Last but not lease would be a nice cap for the post as over time the top of the post will deteriorate