Software
Houzz Logo Print
hdrewh

Wall Mount Toilet Problems

9 years ago
last modified: 9 years ago

Hi All,
First post, hoping to get some help to pass along to my contractor. Geberit 2x4 carrier and Toto wall mount toilet...is moving, along with the wall, enough to crack the grout. Short video (full screen shows it a bit better)

Maybe the carrier, studs and plywood are not completely flush with each other, so that movement is possible?

First experience with this kind of setup for my contractor and plumber, it's just not common where I live.

Contractor is coming back Friday to open up the wall and see what can be done, hoping to get some suggestions here to pass along.

Thanks for any input.
Howard

Comments (10)

  • 9 years ago

    What kind of studs was the unit attached to?

  • 9 years ago

    just regular 2x4's

  • 9 years ago
    last modified: 9 years ago

    My Geberit in wall carrier is bolted to the floor and to the studs on each side and is solid as a rock but I am thinking that if the whole carrier was moving the wall above the toilet would be bowing out with the movement and/or the flush plate would be pushing out of the wall, since it's all one piece.

    I think it has to be something with the horizontal bolts that go through the carrier that hold the bowl onto the carrier.

  • 9 years ago

    That's good info, thanks. Is yours on a tiled wall? Mine is not, and I know Geberit 'recommends' cement board or simar and tile, but I figure if it's installed properly regular 1/2" sheetrock shouldn't make a difference...?

  • 9 years ago

    The finish wall should not have anything to do with it. The carrier should be bolted into the framing of the house and the toilet is bolted onto the carrier. My wall is tile on drywall I think, the cement board stops at the edge of the shower, and the tile only goes to above the flush actuator plate.

  • PRO
    9 years ago

    I'll bet it's a framing problem.

  • 9 years ago

    Does it feel like anything up around the flush actuator is moving? If the whole thing is moving there is going to be movement 4 feet off the finish floor to above that depending on which height the toilet is mounted. If it's not attached to the framing properly and the whole frame is moving, it will be pushing on the drywall at the top of the frame as the whole thing tilts.

    IF it is just the bowl putting pressure on the wall because it's not mounted on the frame correctly all the movement will be around the bowl or below.

    If it can't be fixed by tightening the bolts that are accessible on the sides of the toilet (at least they are on mine), I don't think it matters what it is, the wall has to be taken down to fix it. either to attach it properly to the framing or to see what's going on with the horizontal bolts through the Geberit frame that hold the bowl.

  • 5 years ago
    last modified: 5 years ago

    We just installed a Toto wall mount against drywall and not tile and having same issue ... when you put pressure/weight on the toilet it moves the drywall. The plumber says all was done correctly with toilet install and framing. Contractor to come out tomorrow to remove drywall and we considering installing plywood. The Toto instructions claim it can be mounted on drywall.

  • 5 years ago

    My contractor ended up installing a steel plate behind the drywall and in front of the toilet frame and it's been rock solid ever since. I think there has to be -zero- gap/play otherwise you'll get movement. Good luck.