Software
Houzz Logo Print
webuser_932809283

Furnace fan doesn’t turn on

6 years ago

I have a problem with my AC. I can see that the heat pump is turning outside the house, but the inside fan is not turning. When I turn off the breaker and turn it back on(both breakers I think for inside and outside machines) the inside fan works again. I had a technician come and same thing happened. Turn off the breaker and turn it back on and motor is running. He suggested the capacitor was the problem, so changed it, but today when I turn on the AC, same problem again. Outside fan running, but inside fan not moving. Turn the breaker off and everything works again. What could be the problem?

Comments (8)

  • PRO
    6 years ago

    Unfortunately not all techs are created equal.

    You need someone to fully diagnose what is going on. Given this an intermittent problem it may require some guessing... which may cost you more money to get to the root of the problem.

    In some cases the problem is the last thing you think it is. (even a technician)

    On location experience needed or wait until it quits working all together.

    In this situation I don't even know what I am looking at. So my magic 8 ball, just simply shrugs. Imagine that if you can....

    I service the Katy, Texas area.

  • 6 years ago

    It could be the fan, the relay that turns on the fan, or a loose wire. Intermittent problems are hard to diagnose. You may need to hire a better tech. The first one was guessing.

  • 6 years ago

    There are two types of capacitors for motors: motor start, and motor run capacitors. If a motor start cap is bad, the motor will not run at all or may start very slowly but eventually run. If a run cap is bad, it probably will not run at all. The symptoms you describe do not seem to me (an amateur who has replaced caps in various motors) like a cap problem.


    Possible the motor is overheating and a thermal cutoff inside the motor is shutting it off. If you're able, when it shuts down, immediately open the panel and feel the motor. If it's hotter than blazes there's your answer. That could be caused by motor bearings or fan bearings seizing up.

  • 6 years ago

    Furnace fan doesn’t turn on

    https://www.ductless-mini-split-air-conditioner.org/


    Your split-system cooling system can’t operate unless both units – the indoor evaporator and the outdoor condenser/compressor – are operating. If the outside unit stops working, but the inside unit is still running, with the blower fan operating, you’re still out of luck. The system won’t be cooling your home since both sides of the system need to be operating. When this happens, try the following:


    • Make sure the AC hasn’t been turned off. Typically, there’s an on-off switch in a small box near the outside unit.


    • Check the circuit box to make sure the breaker for the outside unit hasn’t tripped. If it has, turn it all the way off, then flip it back on. If this happens more than once, you’ll want a trusted electrician to determine why the breaker keeps tripping.


    • Make sure the thermostat is set to “cool” and that the temperature setting is lower than the room temperature. (If this is the problem, your inside unit likely isn’t working either.)


    Other Issues Might Be at Fault for Your AC Malfunction

    When the outside unit breaks down but the inside unit is running, the culprit may well be a broken compressor.


    That’s typically a major repair. It might even warrant a system replacement. If the outside condenser/compressor unit is a lost cause, resist the temptation to only replace that unit.


    It’s usually much better from a performance and efficiency standpoint to buy an integrated system, rather than mixing and matching indoor and outdoor units.


    Other potential issues that could shut down the outside unit may include the coils freezing up, a malfunction of the fan in the condenser, an electrical issue, or a problem with the refrigerant line.





  • 6 years ago

    I don’t think it’s the motor because its been off for a couple of days before I started the AC during the heat wave in my area.


    if it’s loose wire why would it start after cycling the breakers?

  • 6 years ago

    Hi, I,m no expert on Ac but I would suggest you go to the thermostat turn the

    system off ( Heat off cool) Then turn the fan on at the thermostat ( Auto On) If the fan Runs then I would think you have a control problem if the fan fails then check out that system.

    Good Luck Woodbutcher

  • 6 years ago

    I tried turning the fan. it didn’t start. Then I turn on the ac and the motor started. So, why does the motor start for the ac but doesn’t work for the fan? Or why there’s wind coming out for ac but not when I turn on the fan?

  • 6 years ago

    My first "guess" would have been the start capacitor, too. However, as that didn't fix the problem, the tech needs to come back and fix it properly. He shouldn't charge any labor for the second visit.