Software
Houzz Logo Print
webuser_742665890

Is this a botched Penny tile install?

5 years ago


Hello! I just had some penny tile installed in my bathroom and although the spacing looks great i can see squares. Its not as obvious as it looks in the pictures but my contractor says its normal and that the tile spacing is good. Is this a grout issue or a placement issue? Or totally normal?

Thank you!





Comments (15)

  • 5 years ago

    Are these tiles matte and polished? In one of my bathrooms, I am putting penny rounds on the wall behind a floating vanity.

  • 5 years ago

    These are matte tiles

  • 5 years ago

    It looks like a nice install but those squares! Do you know if they were all from the same batch/box/lot?


    It looks like a few of the sheets are from a different lot number and don't quite match. If it looks better in person, it might not be a problem once you get the toilet and stuff in there.

  • 5 years ago

    Im going to ask the contractor tomorrow since thats my worry as well. its not as noticable in person but theres definitly something off.

  • 5 years ago

    Has it been grouted?

  • PRO
    5 years ago

    It's not the worst installation I've seen but not the best either. Penny tile can be very difficult to install and look uniform for sure. Could be different lots or could be something amiss with the substrate. Would definitely discuss with your contractor. Good luck!

  • 5 years ago

    I just read yesterday on a different thread that the best installers remove (cut out) some of the outside pennies and then place them manually in the mortar so that you don’t see the lines. That post stated that there were many other forum posts about penny tile.

  • 5 years ago

    Penny tile sheets should be staggered to avoid the obvious lines between sheets.

  • 5 years ago

    We've seen a lot worse photos of penny tile installations here and only a handful of excellent ones. Not sure it is worth tearing out once you put in all the fixtures and cover part of the floor with a nice bath mat.

  • 5 years ago

    Yes its been grouted. Im not sure where the tile is from since i hired a licensed flooring company that does lots of insurance referred jobs and figured they knew what they were doing. Whats most frustrating is that months ago when i met with them nobody said a word about this being a possibility or how hard penny tile was until I met with the overseer the day before the tile was supp to be installed. And even he only said i may see some lines here or there.

  • PRO
    5 years ago

    So you purchased flooring from the same company that installed it? That’s good, at least there won’t be finger pointing. Yes penny is tricky but not impossible to install well. The variations in tile color are especially unacceptable.

  • 5 years ago
    last modified: 5 years ago

    Not a pro, but I thought penny tiles sheets were supposed to be staggered? Considering that the tile installer didn't stagger them, it looks fairly good to me, except for the different dye lots. If they re-do it and stagger it, it will look better, and at that point you can make sure that all the tiles are from the same dye lot.

  • 5 years ago

    The color difference bothers me as much or more than the spacing. Penny tile is a tough product to get great results so it is just one of those products I don't even consider using.

  • 5 years ago

    Builders, designers, resellers, etc... can make all the claims they want, but in the end its the subcontractors who are your installers & builders. You mentioned they're all matte penny tiles, like all tile, lighting makes a huge difference. They could have turned on your interior lights then lay the tile based on how that light reflects off the tile.
    I do not lay tile, (I'm more in the green design build, field)