Software
Houzz Logo Print
prius2ny

How to paint over this?

5 years ago
last modified: 5 years ago

While removing the blinds that were nailed to the wall, I accidentally pulled off some parts of the wall that looks like cardboard (?) underneath it. (See pictures below).

I'm not sure if that is drywall or some other material?


My question is how do I prime and paint over this? What do I use to patch up those holes on the wall and the cardboard-like parts of the wall that ripped out?


Any specific primer?


Thanks in advance!




Comments (7)

  • 5 years ago
    last modified: 5 years ago

    @cat_ky thanks so much. What kind of spackling compound should I purchase? I also heard of joint compound- does either matter?

  • 5 years ago

    i always prime the paper first with an oil based primer or surface sealer (Guardz) to prevent the cardboard from wrinkling from the water in the joint compound, then spackle/joint compound then prime again, then paint.

    prius2ny thanked cleo
  • 5 years ago

    Either will work, but, its a very small job, just buy a small container of spackling, for what you have.

    prius2ny thanked cat_ky
  • 5 years ago
    last modified: 5 years ago

    The best way to do this is first sand the edges around where the blinds were because the paint at the edges is probably thicker than the paint on the wall, and there may be some caulk left on the wall. Next, with your eyes closed, run your hand over the wall and bare area. If your hand can detect a difference in height between the painted and non painted areas, that slight difference in height is going to show after you paint. What your hand feels, your eyes will see.

    If you don't want to see a ghost of the blinds up there, the ideal thing would be to level it out with a skim coat of joint compound on the surface-sealed bare drywall, followed by sanding until it is smooth, which would raise the bare area up to the level of the paint. As Cleo mentioned, after sanding and before skim coating, apply the surface sealer. Then apply another coat of surface sealer over the skim coat before painting.

    So it's sand, plug holes, sealer, skim coat, sealer, paint. I know this sounds like a lot of work, and it is. If you don't mind living with that shadow of the old blind, then it is far simpler. Or if you sand the edges and if it feels smooth between the paint and the drywall, you could skip the skim coat.

    prius2ny thanked graywings123
  • 5 years ago
    last modified: 5 years ago

    I like Dap DryDex spackling compound. Seems to shrink less and dry faster. Goes on pink; turns white when dry. Also, DryDex sands easily.



    Filling the screw holes will be a multi-step process. Fill, dry, sand. Then fill again because the holes are deep and the spackle will shrink.

    prius2ny thanked ci_lantro
  • 5 years ago
    last modified: 5 years ago

    Thank you all so much! I lightly sanded and then filled with spackling compound (Dap - Dry Dex), then used Guardz to seal, and finally Kilz 2 water-based primer.


    But within a few hours i saw tiny bubbles, and when I touched it, and it peeled off in layers.


    Is it bc of the water-based primer?