Software
Houzz Logo Print
morgan_mecham

Cracks along ceiling sheet seams?

4 years ago
last modified: 4 years ago

I have just purchased my first home and do not know much about ceiling work, but I figure that these cracks are along the seam joints because of how regular and grid like they are.
I've always heard that these sheets should be staggered rather than how they are currently placed. Is that correct? These cracks are visible in almost every room of my house.
I notice a bit of waving in the ceiling which I think is consistent to where the sheets would be attached to the beams. Will I be able to fix all of this without having to rehang each sheet?
How much would this type of repair cost?


Comments (3)

  • 4 years ago

    Drywall seams do not have to be staggered. The goal with hanging drywall is to have as few seams as possible when hanging. You have a very very badly finished seams and they tried to cover it up with badly applied stippling . The seams should have been taped, mudded, feathered out and sanded. You are never going to match the present stippling. Definitely done by someone who never done drywall before. The waving is probably due to not enough drywall screws per each sheet. My guess would be they used drywall nails instead of drywall screws because they are cheaper. To fix it you don't necessarily need to take down the drywall, but you have to remove the stippling, the mud on the seams and redo it correctly. Finishing drywall isn't that hard, it just takes some practice. If your going to hire someone to repair it, it probably would be cheaper to have them tear it down and replace.

  • 4 years ago

    I would replace the drywall entirely. Even if you like that pattern, any repair would mess it up. It's not a complicated job-- just about anyone could do it, so you have a lot of options in terms of price and quality. You could pay a handyman to do it for a few hundred, or a drywall guy probably double that. Be sure to inspect the finished product at different times of the day in different light-- ceilings are the least forgiving for imperfections in spackling.


    If you want to learn to DIY, materials are cheap--this is a $150 job. No need to rent a drywall hoist on a room this small-- get a friend to help you lift it up, or make a T out of scrap 2x4s (a.k.a., a "dead man") to prop against the wall and serve as a shelf while you set a few screws in the other side of the sheet, or both.

  • 4 years ago

    Leave it. Many, many homes I've seen including my own have this going on - some worse and some not as bad.