This Coral Gables garage was transformed from a raw, sub-level space into a clean, fully finished room. We ran custom floor-to-ceiling cabinets in a deep navy-blue finish along two walls and wrapped them seamlessly around the corner, holding the reveal lines consistent throughout. A solid butcher-block workbench anchors the center of the run, with a slatwall backsplash above for adjustable hooks and tools, and bank drawers below for smaller hardware. On the adjacent wall, a full-width slatwall panel system adds flexible vertical storage for bikes, ladders, and equipment, keeping the floor clear. Underfoot, a flake epoxy floor coating was applied over a fully diamond-ground slab, creating a seamless, slip-resistant surface built for South Florida's heat and humidity. The powder-coated, moisture-resistant cabinetry gives the space an almost furniture-grade look — a finished room rather than a utility space.