Software
Houzz Logo Print
franktank232

Chip and t budding apples/pears?

15 years ago

Anyone do this? I tried some apples. I'm really bad at this, and a couple of times I cut right through the branch trying to remove a bud! Maybe I'm using too thin of material? I'm using parafilm.

Once I get good at this, I'll be chip budding everything.

Comments (6)

  • 15 years ago

    Frank, I've chip budded a few times, prefer to simply bud if the bark slips (I do a back-up behind W&T, cleft, or bark grafts.) I've found it can be hard to remove the chip OR bud if the budstick is too supple. It bends, and then I cut right through it. But if your knife is truly sharp it's easier, and the budstick can be the same scion as the regular grafts- they're usually stiff enough. I prefer to graft pencil-sized to pencil-sized, and that makes the match easier too.

    If the stock to which you're chipping is very much larger than the source of the chip then you'll only get a match on one side. It can work, but it's iffier.

    I use a budding rubber and parafilm.

    Hope that's some help.

    Good luck,

    M

  • 15 years ago

    When I am cutting under to make the chip I keep my thumb in a position that it can "brake" the cutting and I go slow and make sure the knife isn't sinking too deep. Once you start in you also often have to be lifting up a bit if you want it to keep from going too deep. The same "braking" goes for the cut at the bottom to get the chip out: have your hand positioned so the knife cannot go forward very far without being able to brake the cut. I still occasionally cut too far on both of these cuts, esp. on the first couple each year when I forget how much easier budwood is to cut than dormant scionwood.

    Scott

  • 15 years ago

    Thanks for the info. I've had some that didn't match, so i lined up one side. Who knows how they turn out. Its all learning right now. I did almost cut off my hand on one bud. I kind of use a rock motion when i hit that hard spot under the bud. Maybe my knife (its a grafting knife) is not sharp enough.

    Any way to know if a bud takes or is garbage? I've done peaches, apricots, apples, plums so far.

    I was able to replace the alternator in our Focus this past week, so i'm not totally helpless! :)

  • 15 years ago

    That hard spot can be really hard to cut through on some scions; I also use a rocking motion on the tough ones, I like keeping all my fingers. My hands I keep tense as well, so the muscles will be able to quickly brake a wayward cut.

    To see if your blade is sharp enough hold it up to a light with the edge facing the light. Rock it back and forth so you can look for a reflection up and down the edge. You should see no reflection from the edge and if you do its dull in that spot.

    Lining up only one edge of the bud is something I do probably half the time when doing chip buds.

    You will know if it takes in a few weeks, its usually pretty obvious on chip buds they tend to look shriveled and fall right off when no good. If not sure nick the chip below the bud and look for green.

    Scott

  • 15 years ago

    Frank, I've started doing a lot of chip budding in the last year--pawpaws and apples. For apples I chip bud in late summer. For pawpaws it's late spring after bud break. Apples are really easy--I'm getting nearly 100% take. Pawpaws I still find challenging.

    Make the safe cuts--always away from you and your fingers. No need to take risks. Bottom "stopper" cut first, then the long cut from the top. I use an el cheapo utility knife, and put a new blade in at the start of the day. I wrap with parafilm, unwrap after several weeks.

    Based on some discussion here, I've also experimented with t-budding, sometimes as a backup to the chip. For me, it does seem a little easier to slide that bud into the t than to line up the chip. Experts say the chip has a better take....I don't know. Try some of both and decide for yourself. We're all different.

    Good luck and keep up posted,
    Marc

    PS....looking for pawpaw budding tips

  • 15 years ago

    I've been watching this video and trying to replicate what he is doing.

    http://blip.tv/midfex/tutorial-t-bud-and-chip-bud-fruit-tree-grafting-techniques-350977

    I'll try a few more this evening. A couple of my apricot grafts were no good. I took one off that may have been good! (oops!). Still a few others that look ok so far.