I have an 8 hp B&S Horizontal shaft I/C engine. More specifically Model: 195432 Type:0725 01 Code:89012410 . It is mounted on a Yazoo high wheel S-26. Both were made in late 80's I think. Not much use..Nothing appears to have been taken apart- everthing has original paint.Carburetor had varnish in it ,as did tank .Parts ordered and reassembled carburetor. OK. Due to the length of time it took to get the parts,I can't remember the proper assembly of the throttle link p/n-260872; spring link p/n260478; govenor spring p/n260695. There's lots of holes on the back of control bracket, three in governor lever. Yes, I should've ...but didn't! Does thottle link go in bushed hole of throttle? Other end? Spring link ? Help would be appreciated. I have the B&S parts diagram but the back side of control bracket is not shown. Thanks. Sorry this is so wordy, but should be understandable.