Software
Houzz Logo Print
eedler

Craftsman rider problems when it warms up

18 years ago

I have a 3 year old riding craftsman lawnmower. It has a 18hp OHV intek Briggs engine. After about 1 hour of cutting the engine starts to run rough. When its running rough it sounds like I am running out of gas. Engine sounds like it is going to cut out but revs up and runs ok for a few more minutes then it sounds like it will cut out again. It continues to do this and is extremely annoying. I typically have to let it cool down for awhile before continuing again. Again after some time of riding it will act up. I have loosened the gas cap in hopes that the vent hole in the cap is clogged but that does not make a difference. Any help would be appreciated.

Thank You

Eric

Comments (12)

  • 18 years ago

    Model #'s are always useful!

    What happens if you top off the gas tank? IF it runs good again, I'd replace the fuel filter.

  • 18 years ago

    Better check inside the engine shroud, for a mouse nest. They love to build their nest in amongst the fins, and the spark plug wire. And, that wire is their dessert. They chew off the insulation, for lunch.
    Its possible, if the cooling fins are blocked off, for the engine to get too hot, with results as you describe. And, a mud wasp egg in the gas cap breather hole has been known to shut off the gas supply to the carb.

  • 18 years ago

    Thanks for some feedback... I will post the model number tonight. I do not have that in front of me.. Topping off the fuel tank does not help. I had just replaced the fuel filter, oil, gas, and oil filter. No luck so far.

    As for nests... I will have to double check. I did try to blow everything out with a leaf blower but maybe I need to do a little more inspecting... I initially thought I had the clogged gas cap breather hole. I have run with the gas cap extremely loose, which I would think would allow air into the tank for the gas to drain. No luck there either.

  • 18 years ago

    Inspected for nests and chew'd spark plug cables.. No luck.. All is clean. The model number of the engine is
    31p777-0299-e1

  • 18 years ago

    Did you actually remove the cooling shroud and clean between the fins?
    The problem sounds heat related.

    Also, make sure the vacuum hoses to your fuel pump are intact. Possibly, a marginal connection may "open up" slighty when warm, causing the pump to produce a bit less flow.

  • 18 years ago

    The cooling shroud was removed, the fins were not clogged... The flywheel fan is also all cleaned out.

    I am not sure where the vacuum hoses are. I am not sure if this has a fuel pump, Maybe I am wrong, but I don't think there is one. I can find the fuel solenoid. If you are familiar with the engine, can you tell me where approximately the fuel pump is....

    Thank you
    Eric

  • 18 years ago

    Part N on page 2
    http://www.briggsandstratton.com/pdf/owners_manual/100%5C276344TRI_B-Domestic.pdf

    Looking at the IPL, I don't "think" you have one either. It appears the 0299 Type uses a non pump carb.

    You did use the Briggs WHITE fuel filter, didn't you?

  • 18 years ago

    Looking a little more-
    The White filter(75 micron) is typically used on engines with fuel pumps, while the Red filter (150 micron) is used on gravity fed systems.
    The IPL shows the White filter for the 0299 Type??????

  • 18 years ago

    The white fuel filter is what came with the lawn mower and I have replaced it with the identical type. Thanks for all your help, If anything I am getting to understand and better maintian this small engine....

  • 18 years ago

    I am still having problems, maybe I can shed some more information. In July and August the tractor would run for about 20 mins then shut down, These are on days when its been warmer. Now that in the end of September I can get it to go for almost 1hour before shutting down. and now in October I can get it to run for almost 2 to 2 1/2 hours before it wants to chug and shut down. Its cooler now in October and the tractor has been running longer... In all cases if I let it cool down for 1/2 hour I can get it to go and cut the lawn again.... Any ideas...

    Thanks
    Eric

  • 16 years ago

    My GT500 w/25hp Kohler does this same thing. I have checked the coil after it quits, and both plugs spark, I have been advised to clean the fuel cap vent (which didn't make a difference), I have replaced the fuel filter, and fuel pump as well as the breather tube. Nothing has changed the fact that it quits after about 30-45 minutes. I have taken it to 3 different repair shops and none of them can find anything wrong with it. 2 of them suggested either mowing without the fuel cap, or drilling a bigger hole in it. I am wit's end.

    gunzlingr@gmail.com

  • 6 years ago

    Easy fix. Mine did same thing. Fuel cap breather is toast. I drilled a tiny hole in top of fuel cap and problem was solved. I t took alot of figuring out but it did the trick