Software
Houzz Logo Print
chestnutpatrick

Soil ? For Al and All

18 years ago

I posted this thread in the container forum and soil...

I am planning on making a mix of soil the contains:

Pine Bark Mulch (very fine) - pH 5.5

Peat Moss - pH about 4

I plan on mixing these at a 1:1 ratio. My questions are....

How much lime should I add assuming that I will end up with two yards of soil mix?

Would you add any fertilizer? Slow release?

Do I need to mix this in advance or is the last minute ok?

I am potting up ornamental grass liners.

Thanks in advance.

Comments (6)

  • 18 years ago

    The usual rate of dolomite lime is 50 lbs for every 1000 square feet (approx. 32x32 ft). I think that is to raise the pH one point. Also, finely ground dolomite lime will take a minimum of three years to break down, 1/3 per year.

    Agronomists talk about the top 7" of soil, so if you were to put that into a bucket (!), here's what I'm thinking: Seven inches is 0.5833 of a foot, x 1000 = 585 cu.ft of soil divided by 27 (cu ft per cubic yard) = 21 cu yards in 1000 sqft. If you have two cubic yards, you would use slightly less than 2 lb of dolomite lime for your cubic yard. Since the acidity is quite low, you could probably just say one pound for each cubic yard.

    But this is opinion, not fact.

    But pH is not the whole story. Your two main ingredients have virtually no nutrient value. You're going to have to add some compost at the very least, and if you could find at least a few shovelsful of soil, it would help, too, to add some microbes (damp, active soil, not dust).

    I would check your local nurseries and see if they have some kind of organic fertilizer. It tends to be expensive for large-scale application, but for your small 'plot', it should be reasonable.

    Sue

  • 18 years ago

    For a good container mix, you will need to add something to provide increased aeration - perlite, pumice, Turface, etc. One part any of these to 2 parts of the peat/bark fines. For growing ornamental grasses, I would personally add some coarse (builder's) sand as well. And 1-2# dolomitic lime per cubic yard. A slow release fertilizer like Osmocote at the plug/liner stage would be of benefit and you have the option of incorporating it into the mix or applying as a top dressing. A 50# bag - available at wholesale landscape supply outlets and typically labeled Micromax or Sierra Controlled Release Fertilizer (the wholesale name for Osmocote) - should be sufficient for the amount of soil you project. Larger OG's do not require very much fertilization but if you are growing on for retail sales, I'd top dress 1G or larger containers lightly.

  • 18 years ago

    It's not a good idea to use straight dolomite lime as it is way too high in magnesium. The ideal Calcium to Magnesium ratio is 7:1 by weight; dolomite is 2:1. High Mg makes the soil tight and seriously retards biological action, often resulting in alcohol based fermentation instead of aerobic breakdown.

    The best mix is 2 parts agricultural sweet lime to 1 part dolomite lime; this will give you the 7:1 Ca/Mg ratio.

    With your ingredients I'd recommend a minimum of 4 lbs of the lime mix per yard, or 2 cups per wheelbarrow full. Also add 1/2 cup of sulfate of potash and 1 cup of steamed bone meal to supply potassium and phosphorus and sulfur. Mix it all up, Dampen it well (not wet) and wait a week before planting in it. Liquid fish emulsion would make a good booster fertilizer during the growing season.

    BTW, sulfate of potash is a natural mined product that is approved for certified organic use by the USDA.

  • 18 years ago

    Never, ever assume you need anything in your soil. Instead rely on a good, reliable soil test for that information. Simply putting some organic matter into your soil does not necessarily equate to needing to add some lime, and which lime to add depends on what soil nutrients you might be low on. What is your soils pH now? What is the level of Calcium in that soil? What is the level of Magnesium in that soil?

  • 18 years ago

    Kimmser,
    This is a serious question. Can you do a soil test on a soilless potting medium?

  • 18 years ago

    Yes, it can be done and it has been done. How else would the Scott's people know what to add to the potting soils they market to get the analysis that is on the bag?