Software
Houzz Logo Print
rameses32

17 Hp Briggs and Stratton Vertical OHV Problems

17 years ago

A quick intro, my Name is Charley, I live in Australia, I moved here from Kansas in 2000.

yesterday the engine started pumping out oil through the fuel pump about 100 mils in 10 minutes, it seems to run fine but when I open the oil cap/dipstick the blow back seems excessive, oil just blows out, with enough force to blow the dipstick out like a volcano. DOes anyone know what the compression should be for this engine, I'm just wondering if I didn't break a ring or something. Also I think there might be a knocking in the engine. It was 100 degrees yesterday, but that shouldn't have caused it.

Anyway, thank you for any help

Comments (15)

  • 17 years ago

    Ok, after reading alot of posts on here I relise it needs a valve adjustment, it has been hard starting for a couple months, I even changed the battery to try to fix this problem and it made very little difference, I was about to go buy a new starter, thank goodness I found this forum, I am going out to adjust the valves now. But would this result in excesive crankcase pressure? Also, the engine has 500 hours, is this alot?
    CHarley

  • 17 years ago

    Well sounds like you may have more than one problem and you will have to do more checking yourself to determine just what is going on.

    You really should post the model and type numbers of the engine when asking for help. I assume it is a 31 series from your description.

    Valves needing adjusted is probably the most common cause of difficulty in the engine turning past compression and results in many new batteries and starters being bought needlessly.

    Spewing oil like that is not from valves needing adjusted. Is your crankcase over full? Perhaps from leaking carb needle valve?

    There is naturally some crankcase pressure, if it is excessive, that engine is prone to blowing head gaskets which would cause this.

    I doubt that you have a broken ring, I have detailed instructions for adjusting valves IF you would like them.

    Walt Conner
    wconner5 at verizon dot net (put in proper format)

  • 17 years ago

    Ok, I adjusted the valves and it starts like a new one. It still has excessive crankcase pressure. The carby is full of oil from the crankcase vent tube, and this tube blows big puffs of oil smoke when you turn the engine off, this makes me think you are right about the blown headgasket.
    the engine is Model 31F777 and type 0403E1

    Thanks again
    CHarley

  • 17 years ago

    I would think blown head gasket also.

    Remove the valve cover ans start the engine. Chances are you'll see "vapor" blowing out near the push rod side.
    Have a rag handy-

  • 17 years ago

    Pulled the head off, definately a blown head gasket, thanks everyone.

  • 17 years ago

    Rameses,
    I just acquried a 14.5 OHV B&S on a Murry and the compression is causing difficult starting with a good starter and a new, big car battery. I believe a valve adjustment will remedy this problem. Where did you get information for the procedure of the valve adjustment?

    Thanks, Bob

  • 17 years ago

    Read the posting in this thread by Walt Conner (walt2002). E-mail him at the address he provides (but you have to put it in the standard format as suggested by the "spoken" information he gives for his address). He prefers to do it this way because this allows him to click "Reply" and then "Copy & Paste" his instructions into the reply instead of having to write it from scratch each time someone needs to be tutored.

  • 17 years ago

    Thank you Mownie,

    I have contacted Mr. Connor and he sent me a wonderful set of directions. When I get an overhaul manual (usually full of "grey areas" and questionable directions), Mr. Connors directions should fill in all the gaps plus have some tips and tricks I wouldn't anticipate in a manual.

  • 15 years ago

    I cannot start my mower. I checked the safety switch in the seat and it appears to work fine. The engine turns over but there is no spark. I don't want to take it apart until I know want to look for.

  • 15 years ago

    My motor starts fine and mows for about 5 min then starts to die, have used chock to keep running and it will run for a bit then die, and then it starts right back up but will only run for a short while.
    tazzedok

  • 15 years ago

    I have a 17hp briggs it has gas in carb and it has spark still won't what is the thing under the bowl of carb. With wire stickin out is that a fuel pump

  • 11 years ago

    have 18.5 briggs and stratton put in new cam new head gasket rebuild carb doesnt smoke but have excess pressure in crankcase causing oil to flow out of fuel pump . pulled plug wire turned over with hand on oil fill tube and have suckion start up and have oil all over wouldnt i get some smoke if i lost a ring


  • 11 years ago

    You are posting on a very old thread, might have been better to have started a new one. I suspect a leaking float needle contaminating, over filling, the crankcase. Have you been checking the oil level?

    Walt Conner

  • 11 years ago

    no gas in oil level is always same


  • 11 years ago

    should i have pressure in crankcase


Sponsored
Franklin County's Heavy Timber Specialists | Best of Houzz 2020!