Software
Houzz Logo Print
exmar

Don't overlook the obvious

This is a public service announcement, and while the subject is a tiller, is appropriate to this forum as well.

Over ten years ago, after I'd retired from being an Engineer, decided to get my "dream job" in a large Sears Store in the Hardware, Lawn and Garden Departments, I was hired due to knowledge of all the above. We occasionally got "first dibs" on returned merchandise before it was offered to the public. Picked up a 2HP, 2 cycle, "cultivator" (mini tiller) which cost me $20, would have been put on the floor for $39.95 as is. It was returned as the customer said the tines wouldn't turn, the powers that be decided it wasn't worth fixing the gear case. The obvious problem (to me anyway) was that the throttle cable had slipped out of the "U bracket" and screw that held the outside while the actual inside cable could move. 30 seconds with a Phillips head screw driver and I had a good machine. Used ever since for tilling between rows and spot tilling in flower beds.

Early last spring while tilling the tines stopped turning, engine raced just fine. Giving a cursory look underneath and seeing no rocks or anything, said OK, it's been a good machine. Finished the year with a wheel hole push weeder. I didn't really tear into the machine due to its age. Further, had read a lot of horror story posts on this machine in other forums that the worm gear stripped and wasn't available, just the whole gear case for $200.

Christmas Day, while attempting to overcome "food coma" as we call it in my house, went browsing on Amazon. Found a good price on a Mantis tiller with a couple of attachments and ordered it. Came in a few days, nice machine and really good price. When you get to be my age, wheel hoes are just too much work.

Suffering from Cabin Fever, have been spending a lot of time in the barn working on stuff. Finally decided to look at the tiller with a view of removing the Tecumseh engine and trashing the rest. Lifting it up on the workbench, dropped a wrench, bending over to pick it up, thought I noticed something..... Could just barely see it, but looked like a rock was lodged against one of the tines and the underside of the tine cover, just under the center of the engine. YEP! It was really wedged, had to remove it with a punch and hammer. It was about half the size of a golf ball.

Hmmm, Decided to try and start it with the year old gas (mystery fuel I call today's crap). It started, let it warm up a bit, and goosed the throttle. Tines turned just fine. Wheeled it outside and with sleet bouncing off, tried it in some half frozen ground chewed right in.....

I'd repeatedly revved this thing up when the tines initially stopped revolving which seemed to cause no damage.

So, I guess I was a victim of information overload, or laziness, or mentally was already thinking about replacement due to age. The moral is, DON'T OVERLOOK THE OBVIOUS, coupled with, if you have a good old machine that has served you well...

Now, just trying to figure a good way to tell my lovely bride (AKA The Mean Redhead), that the Mantis was a Valentines day present for her to use in her flower beds, but I forgot to mention it...... :-)

Just sharing,

Ev

Comments (2)

Sponsored