Software
Houzz Logo Print
scooterman_gw

advice on repair

21 years ago

I have inherited an old system (15 plus years) that appears to have been neglected. I had to hire a local company to repair about 6 leaks - as you can imagine, I was not happy when I got the bill. I've decided that all future repairs I'm going to try to do myself to save some $$$. Of course, I've since identified two problems and wanted some advice.

(1) need to repair a leak. My problem is this. First, how do I tell what size pipe to get. I measured the outside diameter to be about 4inch (a large pipe) and but everything I've read suggests that the pipes sizes are usualyy 1/2in or 3/4. Now I know I measured the outside diameter must I'm having a hard time beleiving that the inside is only 3/4inches. Is that possible or is there actually larger pipes?

(2) The elbow to which one of the sprinkler heads is connected is cracked. How do you pull the elbow out of the pipe;; I loosened the clap and pulled but it's lodged in there good. Do I have to cut it off and then connect to the new opening in the pipe?

Finally, any suggestions as to where to buy online misc supplies? It seems that most sotres I found only make sense if you buy a lot (ie, bulk). I just want a few feet of pipe and the necessary fittings.

Thanks,

Comment (1)

Sponsored
Hope Restoration & General Contracting
Average rating: 4.7 out of 5 stars35 Reviews
Columbus Design-Build, Kitchen & Bath Remodeling, Historic Renovations