Software
Houzz Logo Print
pezzuti9

Air layering-What do you do??

18 years ago

I would like to get a feel for how some of you deal with your air layered cuttings once you cut them from the mother tree.



As you can see iside the plastic wrap roots have formed.

After you remove the plastic wrap



do any of you try and remove the moss and arrange the roots before planting or do most of you let the spagum moss stay and plant the root ball just as it is?

One more item. How would you handle the rootball if you where to ship it snail mail. Same questions as above. I'm courious to learn the best method and how you would deal with this matter.

Thanks

Lou NE., PA

Comments (9)

  • 18 years ago

    For shipping I would just leave the moss in place, re-wrapped in plastic (actually I would wrap in newspaper and then plastic, but I still wouldn't remove the moss).

    For potting I would remove the moss, personally. (I would fear that the moss would hold too much moisture and promote root rot in time). To remove I would put the whole thing in a bucket of water and gently stir til the moss fell away.

    Though I will admit I have not done air-layers with figs.

    ~Chills

  • 18 years ago

    The moss can be removed with a bamboo chopstick or skewer. Also, you might want to try air-layering with your normal growing mix (I think I remember reading your trees are in containers). The goal being once the layer is removed from the parent, it can be dropped into a container without removing the medium from the root zone. This will minimize the shock the new tree will go through.

    To add to what Chills said about sending through the mail, wrap in damp newspaper then in plastic.

    ~james

  • 18 years ago

    Lou, How did you handle the banana fig I sent you? That was an air-layer with long-stem sphagnum moss.
    If you used long-stem sphagnum, just plant it as is after removing the plastic. It will not just fall off in water, especially if you have lots of roots. If you had used potting mix (as per loslunas) you could do that, but why bother? Also, I usually trim back the branches and leave just one leaf per branch. This makes it easier for the roots to support the plant.
    By the way, I shipped yours and one other in mailing tubes, but would not do that again as I think pushing and shoving the plant in and out of the tube makes it tough on the roots.

  • 18 years ago

    Great looking root ball there Lou :)

    did you cover the plastic with anything? or leave as is?

    Thanks
    Cecil

  • 18 years ago

    Lou
    How long did it take to get this mass of roots in in air-layering?

  • 18 years ago

    Ottawan -- It took about 7 weeks for me to get root mass.

    Pezzuti -- I just cut off my air-layered 3 days ago & potted it. The whole air-layered piece without removing anything. The less U disturb the air layered portion the better as transpiration via the leaves can take its toll. Watered the cut air-layered & put in shade for at least 2 to 3 weeks.

    Paul

  • 18 years ago

    The postal service has a 25" long and a 38" long shipping tube for priority/express mail. Both have 6" sides which should accommodate most air layers. They come flat so you can tape the root ball to the inside of the tube to prevent sliding, then fold the sides over and stick it together. Also, FedEx has a similar tube (only for express, not ground), and I'm willing to guess that UPS and DHL probably have the same.

    For those who air-layer in the spring, it may not be such an issue if the layering medium is removed before potting up, if the tree is bare-rooted at the end of the season. If the intention is to keep the new tree in a container for a couple of seasons, then I would either remove the layering medium before potting or use the same growing mix to air-layer as the tree will be potted in.

    As for the success of air-layers in different media, I have experimented with my normal growing mix, my former rooting mix, sphagnum moss and rockwool. My experience is that all have about the same success rate. Rockwool is my least favorite since it is difficult to remove the excess moisture from it once it is soaked, and is is difficult to remove from the root zone. Moss is easiest to use when I am setting the air-layer at the same time I am repotting the parent plant, or if I am air-layering a small limb. I use my current growing mix in Air-Pots when air-layering larger limbs. Since I am rooting in the same mix I will be potting in, I can pot the air-layer up without much root work.

    Cecil, I cover my air-layers with foil to keep the heat down. Even this doesn't help much in the summer though. I think I am only going to do fall air-layers in Houston. The fall is still warm enough to allow root growth. Once the layer is removed from the parent and potted up, the temps are still warm enough to allow root growth while the top is asleep.

    Unfortunately, the foil is not a deterrent to squirrels or anything else. I have had many layers disturbed or destroyed by the little sh!ts. Last year I found a pecan in the dried out sphagnum moss I was trying to air-layer a 'Black Jack' with last year.

    I generally (depending on the variety and probably many other factors) see roots in about 4-6 weeks, if the limb is wounded. Otherwise, I have had limbs take several months before there is a visible root.

    ~james

  • 18 years ago

    Your answers where all very informative. I believe I had started this air layering about 6 weeks ago and had the plastic covered with foil after the weather warmed up but during the cooler time I had the foil covered with a dark black plastic as well to help absorb heat.

    Cecil I appreciate your input as well.

    Chills I tend to agree with you entire statement.

    Elder I potted your tree just as I received it out of the box after soaking the root ball sphagnum moss and all for an hour in fresh water. The plant did well. The moss is very hard to remove even after soaking in water and the roots being very fragile make it all the harder to try removing it. I wait until the plant grows out of the container I place it in then I do some root pruning before placing it into a larger pot. It takes me three moves before I finally get it into the final 20-gallon container where it stays for good.

    James very good information concerning shipping boxes as well as your descriptive info on handling the air layering done with different medias.

    Great posts.
    Good to be in touch with the pros.
    Should call this place, "The HOME OF THE PROS".
    Thank you all.
    Lou NE., PA

  • 18 years ago

    Thanks very much, Lou &~James

Sponsored
Innovative & Creative Custom Closet Designer Servicing Franklin County