Chipshot, as we near the end of our remodel, our KA WD is finally being installed. Based on your pictures, I had (dumbly) assumed that it would be an easy installation with our inset cupboards and the cabinetmaker had used all the measurements supplied by KA. However, when we went to install it, we found that we actually had to cut off metal flanges on the sides in order for it to go in (which we did and it has) as well as increase the cutout size. But now we are again looking carefully at your pictures to see if you made a hole for the little blue light in the lower right hand corner. From the front of your drawers, we cannot see anything but in one of the pics that is taken from above and behind the front of the drawer we think we see a little hole down there. The cabinetmaker was saying that with others he has received a little plastic cover for the drawer front to go over the light and give a more finished look to the drawer...did you have something like that? Any insight you can provide will be appreciated. Thanks!