Software
Houzz Logo Print
scrappy25

question on built in GE Monogram fridge instructions

16 years ago

I always like to do research before I purchase an appliance. When I reviewed the installation instructions for the GE Monogram built-in refrigerator, it says, "Monogram built-in refrigerators are designed to be installed with typical 24 3/4" deep cabinetry."

I though that cabinets were exactly 24" deep? Where did they get the extra 3/4 inch? Is it the doors? So does that mean that the GE mongram will not be flush with inset door cabinetry unless the cabinets are pulled out a bit?

Comments (4)

  • 16 years ago

    OK, I was curiouis so looked at the subzero isntructions. For the 700 series, this is copied out of their guide

    "IMPORTANT NOTE: The depth of each integrated model is
    24" (610) from the front of the unit to its back. Your design
    may necessitate moving the unit back or cabinets forward to
    achieve a flush fit. This will require a minimum rough opening
    depth of 25" (635)."

    So is it standard to pull the cabinets out an inch or so to accomodate these built-ins? I will not be installing it, but I need to know this in the design of the kitchen!

  • 16 years ago

    Yes the 3/4" is for the doors which in teh real world finish out at 1" with door bumpers and other gaffs passed down to the cabinet installers from the framers, sheetrockers, trim guys and painters.

    GE does not make a "fully integrated" fridge. So their built in units are not really gonna be "flush" with any cabinets

    Framed inset cabinets are typically 24" including their doors so, accommodations need to be made for all appliances if you want them to be flush, especially with "fully integrated" ones.

    Pulling them forward is one way to do it, making them deeper is another way. Be sure to adjust end panels to suit the design.

  • 16 years ago

    This might help in determining the space needed for a typical Sub Zero refrigerator installation.

    We have a Sub Zero 532 next to a single 21" wide x 24" deep cabinet (and upper cupboard). The items are along a wall that is very flat in its relatively short 6.5 foot length.

    The front edge of the wooden framed cabinet is actually 24 1/16" from the wall. The wooden drawer and doors are 15/16" thick, and the bumper adds another 1/16", so the front surface of the drawer and doors is 25 1/16" from the wall.

    The front edge of the granite counter top on the cabinet is 26" from the wall.

    Sub Zero specifies that there is 23 7/8' behind the aluminum frame that surrounds the refrigerator. The frame is 1/2" thick. In our installation, the forward edge of the frame is 24 5/16" from the wall, so we've obviously got the refrigerator installed more than very tightly against the rear wall.

    I measure that the freezer and refrigerator doors are 26 5/16" from the wall. (That is, the doors and hinges add 2" to the overall depth of the refrigerator.) The door handles stick out another 1/4". Therefore, the overall depth of the installed Sub Zero 532 becomes 26 9/16".

    Obviously, the front surface of the wooden panels on our refrigerator are not in the same vertical plane as the doors on the cabinet next to it. However, the overall effect is that everything is flush. This is likely the case because a pantry is located next to the Sub Zero on its other side, and that pantry sticks out another 2" or so.

  • 16 years ago

    Antss, thanks for the advice.
    Mr Timewise, I appreciate your very detailed measurements. That helps a lot.

    Note to self: allow 1" extra depth with inset doors for built in fridge. Increase depth of side panels accordingly.