HELP! Wayne Dalton garage door opener stopped working

slc2053

18 years ago

Our garage door opener that we have mounted inside our garage stopped working. We assumed it was the battery so we replaced it, but it still isn't working. It's model number 5BWS. We went to their website to see how to reset it (program it) and we followed them but when it says to hit the "wall station light button" and you'll see an LED light go off or hear a beep, neither happens. The light is not on, so it can't go off and there is no beep. Here is a link to the instructions...

http://www.wayne-dalton.com/Files/ProductManuals/Residential_Garage_Door_Openers/idrive/idrive_for_TorqueMaster/Programming_Instructions/Wall_Station/5-button%20wall%20station.pdf

Please, anyone have any other ideas on what we should try? The instructions don't say what to do when you change battery..

Thanks.

Sort by:Oldest

Comments (4)

doorguy06
18 years ago
This is an I-Drive opener. I Recommend you throw it away. They are nothing but junk. You will probably have to call out a tech to take a look and odds are the cost to repair it will be as much as a new opener. The company I work for installs waynedalton products, I install them b/c I have no choice but the one thing I refuse to install is their I-Drive openers.

Get a Liftmaster.
jmagill_zn4
18 years ago
We have the idrive and love it!

Is the electric working to the actual opener? have you tried the handheld remotes?

Ours has two wall stations as well as two handheld remotes.
Related Professionals
Pine Bluff Accessory Dwelling Units · Lake Charles Accessory Dwelling Units · Gulfport Accessory Dwelling Units · Muskogee Accessory Dwelling Units · Waterbury Accessory Dwelling Units · Traverse City Accessory Dwelling Units · Texarkana Home Additions · Cedar Rapids Home Additions · Bloomington Home Additions · Billings Home Additions · Seattle Home Additions · Ocala Carpenters · Bowling Green Carpenters · San Francisco Carpenters · Edmonton Carpenters
derektroy_talktalk_net
17 years ago
I have just had the same problem,remove the two screws holding the plastic cover for the i drive,lever of the cover(it is on clips)on top of the main board are two round brown fuses lift out with bullnose plyers and replace,if you have a problem getting fuses go to wayne-dalton.com and click on the link contact us and ask for new fuses,also your plug should be on a surge protected plug to stop spikes on your main board,needless to say before you start work isolate from electrics first,good luck Best regards Derek.
joel_manhasset-specialty_com
15 years ago
I HAVE A QUANTUM OPENER INSTALLED AND JUST GOT REMOTE
#3973C. I REPLACED THE BATTERY WHEN IT WOULD NOT PROGRAM
BUT HAD THE SAME RESULT. THE PROGRAM LIGHT ON THE QUANTUM
LIGHTS UP BUT THE REMOTE WILL NOT EFFECT IT (CAUSE TO GO OUT INDICATING PROGRAM RECIEVED)THE RECIEVER ANTENEA IS
A GREEN WIRE. IS THE REMOTE AT FAULT OR IS THERE MORE TO
PROGRAMMING THAN WHAT I HAVE DONE?
JOEL