Software
Houzz Logo Print
jaketuo

Advise on HVAC

17 years ago

I am rehabbing a small 2-story w/basement home about 100 yrs old, approximately 1200 sq ft plus will be finishing the basement for an additional 500 sq ft. The house is gutted to the studs and has had the old heating unit removed and also the old damaged and leaky ductwork. I am looking to go with a new dual system of heat pump/furnace/ac. I hope to be able to get a direct vent system so I can get rid of the old chimney and open up the floor plan. The house will be spray foam insulated and have new energy star windows and doors. I like in Pennsylvania and it gets hot and humid in the summer.

I have very little knowledge of current HVAC systems and could use some guidelines and recommendations.

I had one guy out who has a good reputation but seemed very offhand and took no measurements or anything else to size the system. He quoted with no model numbers or any other real info: 3 ton 80% payne gas furnace. A coil and a 3 ton condencer 13 seer also payne w/ 10 year limited warrenty, duct the whole house and install honeywell pro 3000 digital and programable thermostat. price $13000.00

It seemed high to me and lacking in any real info. I need toi get other estimates but also need to know what to ask for and look for when they come out.

Help?

Comments (7)

  • 17 years ago

    You are correct about the questionable quote you recieved. Any HVAC contractor should be performing a heat load calculation by measuring individual room and window dimansions or maybe you have a blueprint that they ca get the info from. You will want a 90% plus efficency gas furnace so that it can be vented with PVC pipe without a chimney. The thermostat quoted is not capable of controlling a duel fuel set up properly, you will need an 8000 series or above. Be sure to ask about the current stimulus tax credit available for qualifying HVAC equipment and installation.

  • 17 years ago

    I am not so worried about the tax credit as i will be maxing out that money with windows and spray foam insulation. Otherwise you are saying that I will need to get a gas furnace over 90% efficiency in order to vent it through the wall directly.

    Am I looking to go the correct way with a heat pump? Are there advantages going with separate furnace and a/c units?

  • 17 years ago

    your choice between a heat pump with gas furnace or just gas furnace with a/c depends on what part of the country you are in and your electric rate vs. propane price.
    You are correct about the 90% furnace. An 80% furnace that you were quoted will need a chimney or a power vent and must be vented with metal venting. A 90% + furnace can be vented with PVC pipe and no chimney.

  • 17 years ago

    jake

    post electric rate and cost of nat gas or propane.

    you are going to alot of trouble and expense rehabbing an old hime. don't install low end HVAC. you want high eff equipment. I can't decide which is worse-Payne or the price. Call a pro who has experience especially with old homes.

    IMO

  • 17 years ago

    14.84 cents per kWh
    $1.38 per Ccf natural gas
    are the current rates.

    My main objective is to be comfortable without going broke with the initial cost. I also need to have a direct vent system so I can get rid of the chimney and open the floorplan in our smaller house. An efficient system that wont cost an arm and a leg each month would be nice too.

    I am overwhelmed by the abundance of choices with this decision as I never have purchased a HVAC system before. I had no idea it was so complicated.

  • 17 years ago

    Hi, still needing help here.

    I want to get some more estimates but need some help beforehand on what type of system would work best for me, and on what questions i should be asking etc.

    Thanks

  • 17 years ago

    bump