Software
Houzz Logo Print
dbk12345

How do I test the contactor on AC unit outside

19 years ago

I had an evaporator freeze-up problem. The blower wouldn't turn on and the HVAC tech said it was the main board. He wanted $1800 to change the board and could't guarantee it unless he also changed the motor for Grand Total of $3,000. I paid the service call fee of $149 and said good by. The whole problem seemed to have started after a lightening storm. I hot wired the blower to ac and it seemed to work fine. I then replaced the main board with a 325878-751 replacement. The self test with the thermostat disconnected works fine and it cycles through as described in the instructions. However, the outside condensor/pump comes on before the fan turns on (fan delayed) and once the set temp on the thermostat reaches its goal, the fan shuts off but the condensor/pump keeps running and the freezing seems to start again. I now can only run the fan continuously while the condensor/pump is running to cool the house down. I can only shut the condensor/pump off by turning off the main switch to the furnace (24 v off). The condensor/pump will even turn on with the thermostat turned to off. Is it a thrmostat problem now? Since the thermostat is connected to the main circuit board perhaps it was damaged as well. I just ordered a new replacement thermostat.

I wondered if I possibly connected the thermostat wires incorrectly to the main furnace control board. How can I test and trace the correct connection from the thermostat to the "zone damper board" board and then to the main circuit board? I have the same thermostat upstairs. Should I swap it and see if it could just be the thermostat or should I do something else?

I also bypassed the thermostat Jumper R to G on Control Board ...blower fan comes on consistently, did it a few times. Once I jump the contacts, the fan stays on even with the clip lead removed. Is this OK?

Jumper R and Y ... Fan goes on consistently but compressor and outside fan do not come on consistently. I tried turning the furnace switch on and off to reset the board but no go. Sometimes the compressor would come on first followed a few seconds later by the blower motor. Another time both came on at once. A few times after this only the blower would come on. Very inconsistent compressor start.

I spoke to the people at EWC regarding any problems with the zone control board. They said if the jumper R to Y gives inconsistent compressor turn on it could be the contactor in the outside unit since jumping R to Y on the main circuit board bypasses the Zone board and relays there. WHAT IS THE CONTACTOR? HOW CAN I DETERMINE IF THIS IS THE PROBLEM AND HOW MUCH DOES IT COST TO REPLACE IT? COULD THERE BE ANOTHER PROBLEM WITH THE COMPRESSOR?? WHEN IT DOES TURN ON, THE EVAPORATOR GETS ICE COLD.

Finally if all is working properly, what is the proper sequence and timing of the blower fan turning on, the condensor turning on, the condesnor turning off and the fan turning off? Should the blower fan come on at the same time as the condensor? Should the fan keep running for a while after the condensor turns off?

Thanks for the help!

Comment (1)