Software
Houzz Logo Print
chueh_gw

motion sensor flood light installation failed?

18 years ago

i have successfully installed 5-6 regular light fixtures. I thought that installing this motion sensor flood light fixture would be no difference from those. However, I spent hours on it, and it's NOT working. The placement of the original flood light is at a corner under the eave in a tight spot. The down-spout was on my way when I tried unscrewing and screwing. The motion sensor light has only one black wire, one white, one green (ground), and other different colors of short wires bunched together. I have never seen so many different wires. That's why I had a very hard time to cramp all the wires inside the plate (round shallow cup), spending a lot of time on doing it. Finally I did finish installation. Then, The testing failed. I waited until dark. Of course, there wouldnot be a miracle for it to work all at sudden, when the test failed. My question is: did i not connect something that i had to connect? However, I did connect the black from the light fixture to the black from the sucket, and white to white, too. That's as far i connected. Well, the nut I used for the black wires felt a little funny; i felt that i could twist and twist and never end twisting (usually you feel the tension when it is tightened). Perhaps the black wires were separating while I was pushing all the bulky wire mass into the cup. not sure. Do I do anything to all other colored wires? However, they did not seem to be messed with, for they were tightened and bunched up by 2 fixed wire nuts (did not seem to mean to be unscrewed or opened).

Thanks...... Well, after all that work, my neck is almost broken (the soil is not even; could not get the right ladder position. Need to struggle with the shorter inverted v position with and wabbling motions. The ladder is all dangerous in any position at that tight corner)

Comment (1)