Software
Houzz Logo Print
dlr98004

prep sink - squareish or rectangular

16 years ago

I've never had a prep sink before and we have an 18" cabinet for the sink on our new island. We plan on undermount stainless sinks - big single bowl for cleanup area and smaller prep sink. I can order either a square shaped one or a rectangular shaped one. Which will be more useful? Square one is 8" deep and the rectangular one is 7" deep (does that matter?) I have not selected faucets yet - I hope to have a pull down or pull out on both sinks - but obviously a with smaller scale faucet on the island. Most of the pictures I see rectangular sinks - so that is probably what I would choose - but had never even considered a squareish sink before - just wanted to get some of your valuable feedback!

Thanks in advance, Diane

Here is a link that might be useful: Mr Direct sinks

Comments (5)

  • 16 years ago

    Mine is squarish -- about 15-1/2 or 16" and the size has been good. I haven't needed more from to back, but you do want enough room to set down a large pot or colander and this is just large enough that I can, but that I have colanders that span across it too. I would prefer the 8" depth or even a 9". The 7" is too shallow for me -- especially if you would drain out boiling water from pasta and such -- too much splash potential.

  • 16 years ago

    I'd say this is definitely personal preference. we have rectangular and I prefer that look, honestly. I also think 7" is prbably plenty for a prep sink, but I'd pull out your favorite colanders and anything else you'd actively use in the sink and measure...Keep in mind that when you need larger capacity, you have your main sink.

    Also, we went with a full size pull down faucet, again personal preference! Our main sink has a higher profile and a separate spray, this sink's faucet is substantial but lower profile so i think they match well.

  • 16 years ago

    Look at all the specs, not just the perimeter pattern. Don't get a deep one unless you first determine whether you need it. Depth of penetration of faucet may also mitigate large/small perimeter factors for sink size. Is there sufficient space on counter to each side of sink if you move from square to rectangular?

    Decide what the sink will be asked to do--shallow prep? dishwashing? hiding dirty dishes? filling dog water bucket? Something else?

    Find the thread about aching back. The trend toward deep sinks is also a trend toward backaches.

  • 16 years ago

    I have to order a prep sink today for a peninsula 52""by54"" by 45"" I have gone back and forth between a Blanco that is 18" long by 15 wide (Internal is 16"" by 13"" by 10""). Or a Blanco that is same length and width, but 7"" deep which would be 8"" undermounted.

    I can always put a rack inside or a colander to make the 10" more shallow. But I won't be able to make the 7/8"" deeper.

    So...tick tock...tick tock. I choose the 10"".

  • 16 years ago

    I had a hard time finding a perfect square sink to fit in an 18" base for the prep sink on our island. In the end, we picked a 16" round sink for couple reasons. First, it fit. Barely. Second, our kitchen is full of lines and few curves. So this was design statement. Third, we wanted to put this on the corner of the island and have it accessible from either side of the corner. Since the square sinks out there weren't perfectly square, I didn't want to go that route. We bought Grohe Ladylux 3 for both the main sink and a smaller version for the prep sink. Plenty of curves. Here's the sink, w/o faucets installed yet.

    Here is a link that might be useful: Our Bungalow and Kitchen remodel blog