Software
Houzz Logo Print
nikkidan_gw

door and drawer pulls...what size?

14 years ago

I'm hoping to do all pulls on my kitchen cabinet doors and drawers. I'm wondering what size pull to put on the different size doors/drawers.

Should I put bigger pulls on the bigger drawers, or use all the same size pulls, but put 2 on the bigger drawers?

Whats the standard pull to drawer size?

Thanks!

Comments (9)

  • 14 years ago

    Here are pics of my kitchen to see how the sizing worked out.

    Here is a link that might be useful: Thread with my kitchen pics

  • 14 years ago

    Breezy,

    I am working on my hardware and have the same shaker style fronts. I think I am correct that your "Thirds" rule is based on the width of the inside panel not the full width of the drawer fronts? If these were slab fronts then the pulls would have been wider correct?

  • 14 years ago

    Hi Todds. People go either way with the Golden Mean on cabs. You can look at just the inset panel or at the entire drawer front. Before my pulls came, I calculated the entire drawer front, rails and stiles. When I walked around eyeballing which size looked good on which drawer, I changed it up a bit here and there. Just go with what looks good IRL.

    If I had slab fronts, my calulcations would be based on the entire drawer. Good thing mine weren't slabs though because my 39" stacks would have needed much longer pulls than I could have afforded! :)

  • 14 years ago

    Breezy,

    While I am pissed that you got finished with your kitchen first I have to say that your pulls look nice and proportional on your drawer fronts ;).

    In your style does the projection and/or thickness of the handle change with the various widths? I am looking at the Hickory Studio style pulls which are square. The thickness of the pulls increases as the width increases. This also affects the projection.

  • 14 years ago

    Todds--at me?!? I'm not done! Have you SEEN my thread with pics? Not. Done.

    I looked at the pulls you mention. No, mine don't have increased projection with increased pull length. The pulls, whether 3.5" or 8", have the same handle thickness and projection. Love that.

    Sounds like you're making good progress though, yes?

  • 11 years ago

    breezygirl, what size pull would you have done on a 27 inch drawer if you had that size? (drawer under microwave) A 6 inch or an 8 inch pull? I have shaker cabinets and can't decide what to do with the 27 inch drawer and its pull size.

  • 10 years ago

    What are those pulls? They are gorgeous! (as is your kitchen).

  • 9 years ago
    last modified: 9 years ago

    I saw on another thread they are the Aubrey pull from Restoration Hardware