Software
Houzz Logo Print
ridley_2004

Bathroom Sink Supply Link Leak

18 years ago

Hello,

I had a leak this morning with the supply line with my bathroom faucet. I had installed the new faucet and supply lines about a month ago. Every thing was working fine until this morning.

The supply line that leaked was the hot water line. It is flexible vinyl, 3/8 OD 1/2" Connector (I think that's how you say it). The line is 16" long, probably 3" longer than really needed but it was either 12" or 16". I hand tighten it (remember hand tighten by me and hand tighten by a man might mean too different things). Then I used my wrench to tighten it a 1/4 turn.

The guy at Home Depot said that I didn't need plumbers tape since the line had compression connections.

So I thought I connected it correctly except it leaked (it leaked at the angle joint meets the supply line). It seemed a little too easy to un-tighten. The cold supply line was not leaking.

Could it have worked it's way loose? Did I do something wrong? Should I have used a braided steel connector? Could the bow in the line have cause the connection to loosen?

Or just maybe I didn't tighten it enough?

Thanks for any advice.

Comments (4)

  • 18 years ago

    I can see two potential causes for your problem.

    1. As you stated, hand tight by a lady is often much less than hand tight by a man, not to say that there aren't some ladies out there that could tighten it to bursting without a wrench, but as a rule a ladies hand tight is a bit less, a typically 1/4 turn past hand tight is a bit light, I generally give them a 1/2 to a full turn.

    2. You initially installed both the lines on cold valves, or at least cold in reference to the hot water temperature, therefore when the hot water flows through the valve there is some expansion in the metal, which could result in a minor leak. In fact, it is best to tighten the valves then use them a few days and tighten them again to make sure they did change with temperature as the water flows through them.

    Now in regards to the steel braid lines, while there are some who swear by them, in truth that nice stainless steel braid is really a false sense of security. In most cases under that steel braid you have the same vinyl or PEX tubing that is found on the ready made lines without the steel braid, and in some instances with the generic stainless steel braid, the braid is actually covering a cheap rubber hose.

    Although everyone seems to disregard them today, the strongest supply tubes are copper tubing or the chrome plated brass tubing that is connected on the angle stop end with a compression fitting and on the faucet end with the manufacturer supplied cone washer, friction washer and compression nut.

  • 18 years ago

    Thanks a lot for the info. I feel better.

    Do you think I should get a new supply line (just got it last month) or can I attach the same one?

  • 18 years ago

    I don't see any reason that you cannot continue to use the line you have, providing that it has not been cross-threaded.

    I would put it back on and tighten it a bit more this time,,,then after about a week of use you might want to snug it again just to be sure its tight. After that you shouldn't have any cause for concern.

  • 18 years ago

    Okay, I put everything back together last night and so far so good. I also stopped by Home Depot yesterday and bought a water sensor for under the sink.

    But can I ask what cross-threaded means? Are you saying as long as the threads are not striped or mis-aligned?